Game Ready 550550-03, 550550-03-RN, 550550-53 User Manual

GRPro™ 2.1 CONTROL UNIT

SUPERSEDED

User’s Manual

MODEL NUMBERS

550550-03, 550550-03-RN, 550550-53

Brought to you by CoolSystems, Inc.

1201 Marina Village Pkwy, Suite 200

Alameda, CA 94501

1.888.GameReady (1.888.426.3732) +1.510.868.2100

www.gameready.com

Game Ready Control Unit User’s Manual PN 703758 Rev C

This User’s Manual is also available online in

English, French, German, Italian, Japanese, and Spanish

at www.gameready.com under Products.

D E S C R I P T I O N O F T H E G R P R O 2 .1 S Y S T E M

SUPERSEDED

The following items are included in your GRPro 2.1 System:

TABLE OF CONTENTS

GRPro 2.1 Control Unit

A Wrap (comprised of an inner ATX Series Heat Exchanger and an outer Sleeve) must be attached to the System to begin treatment. Each Wrap is sold separately and is not included in the System.

Power Indicator

Pressure Backlight

Volume

Power Cord

AC Adapter

Pressure Indicator

Welcome Packet (containing the User’s Manual and other information about your System)

Connector Hose

™ Series Heat Exchanger

Wrap

(sold separately)

Sleeve

Actual Temperature

Detailed Instructions for Use ________________________________ 2

Modes of Operation _____________________________________ 2

Buttons ________________________________________________ 2

Adjusting Temperature __________________________________ 3

Display _________________________________________________ 3

Operating the System ___________________________________ 5

Storage ____________________________________________________ 8

Cleaning ___________________________________________________ 9

Maintenance _______________________________________________ 10

Accessories ________________________________________________ 11

Indications for Use __________________________________________ 11

Contraindications ___________________________________________ 12

General Warnings and Cautions ____________________________ 12

Speciﬁcations ______________________________________________ 13

UL Classiﬁcation ___________________________________________ 14

Troubleshooting ___________________________________________ 15

Warranty __________________________________________________ 18

Med

High

Coldest

Run

Wrap Temp.

Time

C/F

Actual Temperature

55/13

50/10

45/7

40/5

ºF/ºC

Target Temperature

(Celsius/Fahrenheit)

Temperature Knob

Target Temperature

Power

Program

Play/ Pause

Pressure

Low

Off

Sleep Time

Subtract

Add

Time

(Manual Mode)

DETAILED INSTRUCTIONS FOR USE

SUPERSEDED

Do not use this device without your physician’s speciﬁc recommendations for the frequency and duration of your treatments.

The most common recommendation is to use cold therapy at least 4 times a day, for approximately 30 minutes each time, with at least a 30-minute break between treatments. While the temperature is adjustable, it is reported that the greatest beneﬁt from cold therapy is in the 40-60°F temperature range. Generally reported compression recommendations are for “None” to “Low” pressure settings during the ﬁrst 24-48 hours after surgery or injury, increasing to “Medium” or “High” only if it is comfortable after the ﬁrst 48 hours. We recommend that “High” pressure is never applied if you are conﬁned to bed.

Be sure to read further safety warnings on pages 12-13 of this User’s Manual.

MODES OF OPERATION

Manual Mode: The System automatically starts in this mode, and allows the user to

adjust treatment time and pressure settings. Program Mode: This mode allows the user to choose one of six treatment programs that provide therapy for a set time then sleep (no treatment) for a set time, continuously, at a speciﬁc pressure setting. Drain Mode: Allows a user to connect a Hose with a special Hose Adapter (purchased separately) to the unit, enter Drain Mode and have the unit empty the water out of the ice box through the Hose. Drain Mode can be accessed by pressing the program key and toggling through all six programs. To empty water in the System while in Drain Mode, press the program key until you reach Drain Mode, attach the Hose Adapter to the Connector Hose, place the Hose Adapter over a sink, and press the Play button. Drain Mode will run the Control Unit’s ﬂuid pump for up to six minutes (long enough to fully empty the ice box). Drain Mode is indicated by the following icons:

BUTTONS

Power: Use this button to turn the Control Unit on and off.

Program: Use this button to select one of the available Programs or to return to

Manual Mode. See page 8 in this manual for more information on Programs.

ADJUSTING TEMPERATURE

To adjust the temperature being applied during treatment, simply turn the temperature knob towards 3 snowﬂakes for the maximum amount of cold, or towards 1 snowﬂake for the least amount of cold. Notice that as you adjust the knob, the “Target Temperature” on the display will change. The System will automatically adjust to match the temperature you have selected.

TIP: The maximum amount of cold is dictated by the amount of ice in the reservoir and the setting of the temperature adjustment knob. You may need to stir or replenish the ice to achieve coldest temperatures. Ice will melt faster in the acute phases of injury as the Game Ready System is removing greater amounts of heat from the treatment site.

DISPLAY

Status bar:

Other Icons:

Error

Sleep

Battery

Off (Mute)

Indicates selected mode.

Indicates unit is paused.

Indicates unit is running.

Indicates an error. See troubleshooting pages 15-17 for error codes.

Indicates sleep mode time.

Indicates remaining battery capacity.

EN- 2

Play/Pause: Use this button to start or pause a treatment.

Add Time: Use this button to add time in Manual Mode (does not work in Program

Mode). You can add up to 90 minutes. Treatment must be paused in order to add or subtract time.

Subtract Time: Use this button to reduce time in Manual Mode (does not work in Program Mode). You can subtract up to 90 minutes. Treatment must be paused in order to add or subtract time.

Pressure Selection: Use this button to select one of four pressure settings: No Pressure, Low Pressure (5-15 mmHg), Medium Pressure (5-50 mmHg), and High Pressure (5-75 mmHg). Pressure selection is not available in Program Mode. Treatment must be paused to change pressure settings.

Volume: Use this button to select the option of sound or no sound. Push to mute sound. Alarms will still sound even with Volume off.

C/F Button: Use this button to select either Celsius or Fahrenheit on the temperature display.

Backlight: Use this button to turn the backlight on or off.

Temperature:

Actual Temperature:

temperature of the water leaving the Control Unit.

Target Temperature:

temperature setting. The Control Unit will automatically match the Actual Temperature and Target Temperature as closely as possible.

Approximate

Indicates the target

EN- 3

+ 7 hidden pages