Game2Gear RDR101 Users Manual

Game2Gear RFID Reader

Operating Instructions

Connect supplied USB cable to a USB port on your PC.
Connect the small connector on the USB cable to your Game2Gear RFID Reader. A Red
LED should illuminate on the reader indicating that the reader is receivi
the USB Port, and a Green LED should slowly pulsate, indicating that the reader is
functional and ready to scan your item.

Log onto (URL address here). Once logged onto the website, a Game 2 Gear Reader
interface should appear on your Monito
downloading of ActiveX controls. In Internet Explorer, a yellow bar will appear at the top
of the webpage. Click on this bar, and you will be given the option to allow the
download.

The Game 2 Gear Reade
indicate that it is searching for the attached reader. If it cannot find it, it will prompt you
to connect. Once the connection with the reader has been established, you will be
prompted to

Scan your item by passing the reader over the item. When the Authentication Chip within
your item has been located, the Green LED on the reader will beginning to flash rapidly.

scan your item.

r Interface will prompt you to do what is necessary. First it will

r. If not, insure that your Internet Browser allows

ng power from

The scan is now complete. Your Game 2 Gear Interface will n
of your item

Changes or modifications to the Game 2 Gear Reader not expressly approved by
Game 2 Gear shall void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.

.

CAUTION TO THE USER

ow confirm

the authenticity