Gamber-Johnson MAX3 User Manual

INSTALLATION INSTRUCTIONS

attaching your device to the device end of

Product Revision Form

maX

3

Mounting System

Rev.B

INST-494

Printing Spec: PS-001

Round Plate

Extension

Knuckle

Knuckle

Vesa Plate

Device End

1. Secure Round Plate or Quick Release Mount to mounting

surface using ¼” hardware.

2. Attach the Suction Cup Mount to a hard flat surface. Clean

the mounting surface and the rubber suction cup before

pressing the suction cup against the mounting surface and

pushing down the locking lever.

Note: The Suction Cup Mount is not intended for use in a

vehicle.

3. Assemble components using Thread Locking Adhesive

supplied with the maX3 Knuckle.

4. If using an Extension it must be mounted to the mounting

plate on the Base End. Do Not Use Extension On Device

End Of Mount.

Thread Adapter

Round Plate

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© copyright 2012 Gamber-Johnson, LLC

Quick Release

Mount

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

5. Allow Thread Locking Adhesive to cure for a minimum of

12 hours before

the mount.

Base End

Suction Cup

Mount