Gamber-Johnson DS-148 User Manual

INSTALLATION INSTRUCTIONS

Product Revision Form #

DS-148 VEHICLE BASE
DODGE NITRO (2007+)

JEEP LIBERTY (2002-2005, 2008+)

Rev D

Printing Spec: PS-001

WARNING:
The DS-148 is designed to fit in 2002-2005, 2008+ Jeep Liberty vehicles only.

This vehicle base should only be installed if a person never sits in the front
passenger seat and the passenger side air bag is deactivated.

Installing this base into 2006/2007 vehicles will compromise the vehicle airbag
safety system, possibly endangering vehicle occupants.
Seat bolts in 2006/2007 vehicles are tied into the airbag sensor system.
Loosening or removal of seat bolts in 2006/2007 vehicles will require recallibration
by a certified DaimlerChrysler Jeep service technician.

Failure to comply with this warning may lead to serious injury during sudden
braking or accidents.

INST-307

The

DS-148

bolts.

is a No Holes Board base that mounts to the passenger side seat

Installation:

1. Attach the Lower Tube being used, to
the base with hardware supplied.

2. Remove the front two seat bolts that
hold the passenger seat to the floor
and loosen the two rear seat bolts.

3.Place the small tab over the top of the
seat mounting bracket near the
passenger side door. Slide the side of
the base with the pole attached under
the seat mounting bracket near the
center console.

4. Reinstall the two seat bolts to
compress the base and passenger seat
to the floor, tighten two rear seat bolts.

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© Copyright 2012 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

1/1