Page 1
INSTALLATION INSTRUCTIONS
Product Revision
7170-0218
Rev.C
Form
INST-635
KIT - TABLET DISPLAY MOUNT,
9" LOCKING SLIDE ARM, KEYBOARD TRAY
7170-0218-01
KIT - TALL TABLET DISPLAY MOUNT,
9" LOCKING SLIDE ARM, KEYBOARD TRAY
Printing Spec:
Assemble 7170-0218 and 7170-0218-01 Kit components as shown below.
Refer to the instruction sheet supplied with each component for details specific
to the component.
2X .25-20 x 1.00 HEX HEAD BOLT
STEEL BACKUP PLATE
PS-001
7160-0494
TABLET
DISPLAY MOUNT
(INST-606)
or
7160-0529
TALL TABLET
DISPLAY MOUNT
(INST-620)
7160-0498
KEYBOARD TRAY
(INST-521)
NYLON BEARING
NYLON BEARING
STEEL BACKUP PLATE
REMOVE HOLE PLUG
4X .25 FLAT WASHER
7160-0220
9" LOCKING SLIDE ARM
4X .25-20 NYLOK NUT
Product Mounting Disclaimer
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© Copyright 2014 Gamber-Johnson, LLC
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
(INST-451)
Loading...