Gamber-Johnson 7170-0191 User Manual

INSTALLATION INSTRUCTIONS

Form Product Revision

7170-0191

Rev.A

MOBILE DEMAND KEYBOARD BRACKET

Printing Spec:

The purpose of this instruction sheet is to illustrate the manufacturer's recommended method for
installating the Mobile Demand Keyboard Bracket. The bracket offers an ergonamic
solution that secures a keyboard to the mobile demand cradle or docking station. The
installation will require a phillips screwdriver and a 30mm wrench.

COUNTERSUNK
SCREWS

INST-611

PS-001

30mm Jam Nut

MAX3 EXTENSION

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© Copyright 2013 Gamber-Johnson, LLC

AMPS TO MAX 3
STUD ADAPTER

MAX3 KNUCKLE
MEDIUM

SCREWS

MAX3 ROUND PLATE

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

Begin by installing from the top the 4 countersunk1.
8-32 screws to secure the Max 3 Stud Adapter to
the cradle/docking station.

2. Apply thread locker to the Max3 Extension tube and
connect the Max3 M20 Thread Adapter to the
Max3 50mm Extension. Screw the Max3 Extension
bar into the large threaded hole in the Max3 Stud
Adapter. Thread the 30mm nut and tighten until the
Max 3 extension is secured to the bracket.

Apply red
Threadlocker

3. Apply thread locker to the Max3
50mm tube and insert the Max3
Knuckle to the Max3 Extension as shown.

Apply red
Threadlocker