Gamber-Johnson 7160-0573-xx User Manual

INSTALLATION INSTRUCTIONS

Product

Getac S400 Cradle

Revision

Rev. A

Form

INST-649

7160-0573-00

Printing Spec:

This instruction sheet is for the following products:

1. 7160-0573-00 -- Cradle, Keyed Alike, No RF.

Figure 1

*These instructions are for the cradle only. For instructions on features, set-up and
operation of the Getac S400 computer, please refer to the manuals provided with
the computer.

PS-001

**This cradle is designed to be used with a variety of Gamber-Johnson mounting
systems. Installation instructions for Gamber-Johnson products are provided with
each individual product.

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installa tion or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installa tion or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the loc ation of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the loc ation of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© Copyright 2014 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

Page 1 of 2

Inserting the computer into Cradle

Make sure that the cradle Latch is in the 1.
open positon before inserting computer.
With the computer held at an angle
insert the front edge of the handle under
the front tabs. (see Figure 2).

Latch

Finish by setting the back of the 2.
computer onto the cradle so that it is flat.
Press the latch until it is fully engaged
and remains closed. (see Figure 3)

Figure 2

To remove computer make sure 3.
computer is turned off and reverse
procedure above.

4. The Screen Support provided with the
cradle can be attached to the right or
left side. Use the supplied #8-32 x .38
long screws to attached the screen
support to the cradle.
(See Figure 4)

Figure 3

#8-32 x .38 Screws

Figure 4

Page 2 of 2