Gamber-Johnson 7160-0570-xx User Manual

INSTALLATION INSTRUCTIONS

Product Revision

Cradle - Getac B300

7160-0570-00 No RF

Rev.A

Printing Spec:

Form

INST-648

PS-001

7160-0570-00 Cradle is compatible with
1st-5th generation Getac B300 computers.

Computers can be identified by the p/n
found on the bottom.

1st generation 52628144xxxx
2nd generation (B300-X) 52628317xxxx
3rd generation (B300-H) 52628417xxxx
4th generation (B300-G4) 52628540xxxx
5th generation (B300-G5) 52628591xxxx

*These instructions are for the cradle only. For instructions on features, set-up
and operation of the B300 computer, please refer to the manuals provided by Getac with
the computer.

**

This cradle is designed to be used with a variety of Gamber-Johnson mounting
systems. Installation instructions for other Gamber-Johnson products are provided with
each individual product.

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installa tion or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the loc ation of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© Copyright 2014 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

Page 1 of 3

B300 CRADLE FEATURE IDENTIFICATION

Alignment Pin

Interlock Pin

Front Retainer

Connector Bracket

Alignment Pin

Docking Handle

Push Button Lock

Page 2 of 3