Gamber-Johnson 7160-0529 User Manual

INSTALLATION INSTRUCTIONS

Product Revision Form

7160-0494 & 7160-0529

MOTION ATTACHMENT ­DISPLAY MOUNT - CLAMSHELL

Display Mount

The Display Mount Bracket is attached
to the Clamshell with (4) .38-16 carriage bolts,
flat washers and nuts.

Depending on the equipment being installed the
Display Mount Bracket can be repositioned
approx. 2.0" vertically or approx. .5" side-to-side.

If needed the Clamshell handle can be
repositioned on the opposite side.

If the Mount will be permanently used in
a vertical position (not tilted forward),
a .25-20 bolt can be installed thru
the Clamshell, locking it in position.

Rev. B

Printing Spec:

Bracket

INST-606

PS-001

(4) .38-16 bolts,
washers & nuts

Handle

Clamshell

NEC Triangle

75mm VESA

Gamber-Johnson

2 x 4

Gamber-Johnson

3-Hole in-line

AMPS Horizontal
AMPS Vertical

Several common mounting hole
patterns are located on the
Display Mount Bracket.
Attach the equipment being used
with appropriately sized hardware.

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© Copyright 2014 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

1/3

1X .25-20 Hex Head Bolt

2X .25-20 Carriage Bolts

Steel Backup Plate

Clamshell

Display Mount

Nylon Bearing

Mounting Surface with

Gamber-Johnson Swivel Pattern

Nylon Bearing

Steel Backup Plate

3X .25-20 Nylok Nuts

The Clamshell Display Mount can be
mounted on any Gamber-Johnson
pole or console box with a swivel
pattern cutout.
Assemble the components as shown
above.
Tighten the .25-20 nylok nuts to get
the desired amount of friction when
swiveling the Display Mount.

2/3