Gamber-Johnson 7160-0520 User Manual
INSTALLATION INSTRUCTIONS
Form Product Revision
7160-0520
Rev.B
INST-615
Base, Chevy Impala & Malibu 2014+-, No Drill
Printing Spec:
PS-001
•You must read and follow all of these installation instructions. Failure to follow the installation
instructions may result in serious bodily injury or death
•DO NOT install or use this assembly in the area in which the airbag on the vehicle may be
deployed. The installer and user of this assembly are responsible for installing and using this
assembly outside the area in which an airbag may be deployed. (See Product Mounting
Disclaimer Below)
•Keep these installation instructions with the product and readily available in the vehicle
for future reference of other users of the product.
•Additional copies of the installation instruction can be obtained from Gamber-Johnson.
If you need assistance or have any questions, go to www.gamberjohnson.com or
call Gamber-Johnson at 1-800-456-6868.
•DO NOT remove the warning label form product under any circumstances.
DS-STEP
RECTANGULAR
SLOTS
VEHICLE BASE
OPTIONAL
FLOOR BOLT HOLES
T-BRACKET
Product Mounting Disclaimer
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© Copyright 2013 Gamber-Johnson, LLC
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Remove Front Passenger Seat:
Slide the seat forward and remove the rear seat bolts with a T50 bit. See Figure1.1.
Slide seat backward, now lean seat forward and slide out of the front hook slots, and set 2.
seat out of the way.
Figure 1.
Install Vehicle Base:
Set vehicle base in place to allow seat hooks to slide through the rectangular slots in the 1.
base. See Figure 2.
Hook seat back into slots. 2.
Install T-Brackets using provided hardware. The tab of the bracket will be between the 3.
vehicle base and the seat rail. See Figure 3.
Slide seat forward and replace rear seat bolts.4.
Attach the DS-Step with the hardware provided. See Figure 4. 5.
Figure 2.
Figure 3. Figure 4.
NOTES:
If additional stability is required, use the optional floor bolt holes. Before drilling the holes 1.
ensure the area underneath the floor is clear.
2. Vehicle with power seats: rise the seat above for maximum seat travel.
Loading...