Page 1
INSTALLATION INSTRUCTIONS
Product Revision
7160-0507
Rev.A
Form
INST-610
HP OFFICEJET 150 Printer Mount
Printing Spec:
The 7160-0507 HP OfficeJet 150 Printer Mount is designed to hold HP OfficeJet 150 Mobile all-in-one
printer and is typically used with a Gamber-Johnson DS-74-L mount as described below.
The Printer Mount can also be installed in other arrangements, but the installer may need to
supply longer mounting hardware and spacers.
The Gamber-Johnson 7160-0351 isolator mount can be used with the printer mount for extra
protection against shock and vibration.
A 7/16" Socket & Rachet or Wrench and a Phillips Screwdriver are needed for installation.
PS-001
Back BracketsSide Brackets
1. The 7160-0507 Printer Mount is shipped
in it's most compact form.
Loosen nuts securing the side and
back brackets to open the printer
mount.
Side Brackets
Product Mounting Disclaimer
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© Copyright 2013 Gamber-Johnson, LLC
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Page 2
2. Typical install is a DS-74-L mount
attached to vehicle base or pole.
DS-74-L
Vehicle Base/Pole
3. Attach printer mount to DS-74-L
with .25-20 screws, washers & nuts
supplied in hardware bag.
.25-20 Flat Head Screws,
Washers and Nylok Nuts
4. Insert printer into printer mount.
Center printer so paper feed doors
can be opened.
Moved side and back backets against
printer body and tighten in place.
Attach and secure power and
data transfer cables.
Loading...