Gamber-Johnson 7160-0499-01 User Manual

INSTALLATION INSTRUCTIONS

Product Revision

7160-0499-01

SCANNER HOLDER ASSEMBLY

Rev.C

Printing Spec:

Form

INST-624

PS-001

The following instruction sheet is for mounting the part numbers listed
above. These mounts are designed to attach to the pillars of various
fork trucks.

The assembly attaches to the overhead guard leg on the fork truck. It can fit a
rectangular pillar from 1 1/2" to 5" wide. The mounts are held in place with
3/8" dia. carriage bolts.

Attach the Holder assembly to the pillar using the 3/8" carriage bolts and
back plate.

The assembly should be positioned so the top surface of the mount is relatively
level. (See figures 1 & 2).

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© Copyright 2013 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

1 of 3

Figure 1.- Example of Assembly
in Secure position

Position so this surface
is relatively level

Position the 3/8 bolts as close to
the pillar as possible to prevent
bowing the components

Please note the orientation of
bends on backer plate

7160-0538 does not receive an adjustment lever so
ignore the lever shown.

2 of 3