Page 1
INSTALLATION INSTRUCTIONS
Product Revision Form
7160-0499
Rev.B
INST-601
SCANNER HOLDER ASSEMBLY
Printing Spec:
PS-001
The following instruction sheet is for mounting the part numbers listed
above. These mounts are designed to attach to the pillars of various
fork trucks.
The assembly attaches to the overhead guard leg on the fork truck. It can fit a
rectangular pillar from 1 1/2" to 5" wide. The mounts are held in place with
3/8" dia. carriage bolts.
Attach the Holder assembly to the pillar using the 3/8" carriage bolts and
back plate.
The assembly should be positioned so the top surface of the mount is relatively
level. (See figures 1 & 2).
Product Mounting Disclaimer
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© Copyright 2013 Gamber-Johnson, LLC
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
1 of 3
Page 2
Figure 1.- Example of Assembly
in Secure position
Position so this surface
is relatively level
Position the 3/8 bolts as close to
the pillar as possible to prevent
bowing the components
Please note the orientation of
bends on backer plate
Note: the adjustment handle
can be tightened. This will lock
the lower section & provide a
stable position that will allow
for data entry by the end user
Note: Please tighten to
class 5 bolt specs
(65-88 inch-pounds)
2 of 3
Page 3
The components to build the scanner holder assembly
are provided.
Scanning Gun, Mounting Bracket
15030
.25" x .625 Flange-Head Bolt
14613-0001
Vinyl Cap
15032
1/4 Flat Nylon Washer
4130-0065
Adjustable Lever
14434
1/44 Flat Metal Washer
3130-0027
Scanning Gun, Stabilization Brace
15031
3 of 3
Loading...