Gamber-Johnson 7160-0497 User Manual

INSTALLATION INSTRUCTIONS

RevisionProduct Form

7160-0497

Rev.A

INST-600

Motion Attachment - 6" Arm & Clevis

Printing Spec:

PS-001

WARNING

•The Arm Assembly and computer Cradle or Dock must be positioned away from the driver
and the airbag deployment zone when the computer is not being used and especially when
the vehicle is in motion.

•High speed vehicle turns may cause the arm to swivel, interfering with the driver or other
equipment.

•Any equipment positioned in front of an airbag can cause serious injury or death if an airbag
deploys, as in an accident.

Attach Arm Assembly to the bottom
side of computer Cradle or Dock with
the (4) .25-20 x .50 long Socket Button
Head Screws supplied with the Cradle
or Dock.

Remove the .25-20 nylok nuts and flat
washers from the adapter plate.
Place the adapter base on the upper pole
assembly, inserting the threaded studs
through the two radial slots.

(3) .25 Flat Washers

Place the washers and lock nuts on the studs
and tighten.

(3) .25-20 Nylok Nuts

Unscrew the tilt knob to loosen clevis
assembly and set the amount of tilt
Lock in place by tightening knob.

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installa tion or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installa tion or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the loc ation of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the loc ation of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© Copyright 2013 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

1/1