Gamber-Johnson 7160-0422 User Manual

INSTALLATION INSTRUCTIONS

Product Form Revision

7160-0422

LEG KIT - CHYRSLER/DODGE - RAM ­1500 & 1500SSV - 2011+

1/4-20 x 2.00 Socket

Button Head Screw

Jam Nut

Rev.B

Printing Spec:

Rear Leg

INST-569

PS-001

Tab

Clamp Plate

1. Remove center seat section and
seat brackets.
Note the mounting points for the
Front Leg - a M8 threaded hole toward
the drivers side, a thru hole toward the
passengers side (under carpet).

M8 threaded hole thru hole

thru holethru holethru hole

Front Leg

2. Assemble 1/4-20 x 2.00" Button Head
Screw, jam nut and Clamp Plate to
Front Leg as shown above.
Insert tab on Front Leg into thru hole
as shown in photo.

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installa tion or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installa tion or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the loc ation of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the loc ation of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© Copyright 2013 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

1/2

3. Attach Front Leg to center seat section
mounting point, reusing original seat bolt or
the M8 bolt supplied in the hardware bag.

4. Tighten the 1/4-20 x 2.00 Socket Button Head
Screw with a 5/32" Hex bit against Clamp Plate,
until the Front Leg Tab is wedged in mounting hole.

Tighten the Jam Nut against Front Leg to lock the
Button Head Screw in place. Applying a
threadlocking adhesive to the screw and nut
is recommended.

5. Attach Rear Leg to center seat
section mounting points,
reusing original seat bolts or the M8
bolts supplied in hardware bag.

6. Attach Top Plate using 3/8- 16 x .75 bolts
and washers supplied in hardware bag.

2/2