Gamber-Johnson 7160-0417 User Manual

INSTALLATION INSTRUCTIONS

Product Revision Form #

7160-0417

Base - VW - Jetta/Passat - 2008+ - No Drill

WARNING

•You must read and follow all of these installation instructions. Failure to follow the
installation instructions may result in serious bodily injury or death.

•Do not install or use the 7160-0417 Assembly in the area in which the airbag on the
vehicle may be deployed. The installer and user of the 7160-0417 Assembly are
responsible for installing and using the 7160-0417 Assembly outside the area in which an
airbag may be deployed. (See Product Mounting Disclaimer Below)

•Keep these installation instructions with the product and readily available in the vehicle
for future reference of other users of the product.

•Additional copies of the installation instructions can be obtained from Gamber-Johnson.
If you need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.

•Do not remove warning label from product under any circumstances.

Rev A

INST-565

#1. Attach the lower pole to base in
desired location using the 3/8-16
hardware supplied with the pole
assembly.

#2. Move the passenger seat backward
to gain access to two seatbolts which
attach the front of the seat frame to the
vehicle floor.

#3. Remove the front seatbolts using a
10mm XZN (Triple Square) bit.

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© copyright 2012 Gamber -Johnson, LLC

If y ou need assistance or have questions, call Gambe r-Johnson at 1-800-456-6868

1 of 2

#4. Lift the seat slightly and insert the base between the seat frame and the vehicle
floor. Line-up notches in base with seatbolt holes. Re-install the seatbolts.

#5. Complete the install by attaching upper pole, motion attachment and dock or
cradle assemblies as required.

WARNING

•The Upper Pole, Motion Attachment and Dock or Cradle should not be positioned in the area
where the airbag may be deployed.. DO NOT position the equipment in front of an airbag.
Equipment positioned in front of an airbag may cause serious injury or death if an airbag is
activated, such as in an accident.

•If installation of the equipment requires that the equipment be placed in front of an airbag,

the airbag should be deactivated. In order to secure permission for deactivating the airbag
you must contact the National Highway Traffic Safety Administration at
gain permission to do so. If you have any questions or need assistance, call
Gamber-Johnson at 1-800-456-6868.

•High speed vehicle turns may cause parts of the assembly to swivel, interfering with the

driver or other equipment.

1-800-424-9393 to

2 of 2