Gamber-Johnson 7160-0384 User Manual

INSTALLATION INSTRUCTIONS

Product Revision Form

7160-0384

Rev.A

INST-547

DISPLAY MOUNT ASSEMBLY

Printing Spec: PS-001

The Display Mount Assemembly is a clam shell type mount designed for light
weight displays. The Display Mount can hold displays that use either the
AMPs or NEC hole plattern.

Disassemble the Display Swivel from the mount and attach the customer
supplied displ ay using the screws provid ed with the display. Reattach the
Display Sw ivel to the mount and tighten the 3/8" nut so the friction bearings are
hol d in g the display in a stationary prosition .

The Base Swivel can be mounted to a flat surfa c e with the 1/4" x 1" long
carriage bolts, flat washers, and nylok he x nuts supplied in the hardware bag.

Display mounting
screws

Display

Friction Bearing

Friction Bearing

Backing Plate

Washer

3/8" lock nut

Display Swivel

Base Swivel

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© copyright 2011 Gamber-Johnson, LLC

If y ou need assistance or have questions, call Gambe r-Johnson at 1-800-456-6868