Gamber-Johnson 7160-0351 User Manual

INSTALLATION INSTRUCTIONS

Product Revision Form

7160-0351

ISOLATOR ASSEMBLY - RING & BUSHING

Rev.A

Printing Spec: PS-001

The 7160-0351 isolator assembly is a shock and vibration isolator assembly designed for use with the
NotePadV and other Gamber Johnson products that have the standard 2" x 4.093" hole pattern. It is
designed to mount on top of Gamber Johnson motion attachments (DS-CLEVIS,
QUAD-MOTION-TS3, MONGOOSE, LOWSWIVEL, etc.).

NOTEPAD V

VIBRATION ISOLATOR

1/4-IN FLAT WASHER

1/4-20 x .63 HHCS

1/4-IN FLAT WASHER

INST-536

1/4-20 x .50 HHCS

Attaching the Isolator Assembly to a NotePadV:

1. Align the center of mass of the computer and cradle over the middle of the vibration isolator.

2. Secure the isolator top plate to the cradle with the 1/4-20unc bolts and washers supplied with the
cradle.

3. Secure the clevis to the bottom isolator plate usin g the 1/4-20unc x 1/2" long hex head bolts and
flat washers found in the hardware bag.

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© copyright 2011 Gamber-Johnson, LLC

If y ou need assistance or have questions, call Gambe r-Johnson at 1-800-456-6868

SHEET 1 OF 2

Explode d view of Is olator Assemlby (shown upside down for clarity)

#10-32UNF X .25"

PHILLIPS PAN HEAD SCREW

WASHER

ISOLATOR RING

ISOLATOR BOTTOM
PLATE

ISOLATOR BUSHING

ISOLATOR TOP
PLATE

SHEET 2 OF 2