Gamber-Johnson 7160-0344 User Manual
INSTALLATION INSTRUCTIONS
Product Revision Form
7160-0344
PDRC Extension Cable Assembly
Rev.A
Printing Spec: PS-001
STEPS FOR ASSEMBLY:
1. Remove from h ar dware bag (4) 1/4" Hex Standoff and attach to PDRC
Cable serial connector and video connector that comes with the PDRC unit
making sure that they are tight. See Figure below.
INST-531
1/4" Hex Standoffs
2. Remove attachment pins from 15' Serial Extension Cable (14403).
Unscr e w the pins from th e male end and place 1 washer (9000-0045) over
eah pin and replace. See Figure below.
Washers
Product Mounting Disclaimer
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2011 Gamber-Johnson, LLC
If y ou need assistance or have questions, call Gambe r-Johnson at 1-800-456-6868
STEPS FOR ASSEMBLY:
3. Remove attachment pins from 15' Video Extension Cable (14402).
Unscrew the pins from the female end and place 2 washers (9000-0045) ov e r
eah pin and replace. See Figure below.
Washers
4. Assemble all three Extension Cables to 6' PDRC Cable as shown in
Figure below.
5. Apply Shrink Tubing over the connections and shrink in place. This is
especially important for the USB Cable as there is no retension pins for this
part of the assembly. Note that the USB Repeater is attached to this
connection. See Figure above.
Loading...