Gamber-Johnson 7160-0343 User Manual
INSTALLATION INSTRUCTIONS
Product Revision Form
7160-0343
BRACKET - PRO.FIT - BALL AND PLATE
LOCK NUT
LOCK PLATE
Rev.A
Printing Spec: PS-001
INST-530
BRACKET
The Pro.Fit Bracket is design to mount a cell phone, GPS or other small
electronic device to the right hand side of Gamber-Johnson MAG Dock or
Note Pad V products. The bracket is compatible with many products
available from Pro . Fit Intl. Visit www.Pro-fit-intl. com or call
1-800-388-0073 for compatible acce ssor ies.
Note: Holder and device must not exceed 1.5 pounds.
Product Mounting Disclaimer
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2011 Gamber-Johnson, LLC
If y ou need assistance or have questions, call Gambe r-Johnson at 1-800-456-6868
Installation on MAG Docks:
The bracket can be installed in conjunction with a Screen Support and/or
LED Light Assembly.
1. Install bracket to MA G Dock using supplied screws and washe rs. Caut ion:
Do not over tighte n screws as damage may result to MAG Dock th r e ads.
2. Install Pro.Fit accessory to Lock Plate
3. Loosen Lock Nut and sn ap Lock Plate/Lock Nut assembly onto ball.
4. Adjust position as required and tighten Lock Nut
MAG DOCK
7160-0096
7160-0060
7160-0251
OR
7160-0252
NOTEPAD V
Installation on NotePad V:
The bracket can be installed in conjunctionwith a Screen Support or LED
Ligh t Assem bly.
1. Install Bracket to NotePa d V using supplie d screws an d washers.
2. Install Pro.Fit accessory to Lock Plate
3. Loosen Lock Nut and snap Lock Plate/Lock Nut assembly onto ball.
4. Adjust position as required and tighten Lock Nut
Loading...