Gamber-Johnson 7160-0301 User Manual

INSTALLATION INSTRUCTIONS

Product Revision Form #

7160-0301 VEHICLE LEG KIT
FORD F-250, F-350, F-450, F-550, F-750 SUPER DUTY (2011+)

Note: Part number 7160-0301 Rev.C will fit vehicles with Manual 4 x 4 Lever.

Rev C

Printing Spec: PS-001

WARNING

•You must read and follow all of the installation instructions. Failure to follow all of the installation
instructions may result in serious bodily injury or death.

•Do not install or use the leg kit in the area in which the airbag on the vehicle may be deployed if it is
activated. The installer and user of the Ford Super Duty Leg Kit are responsible for installing and using
the mounting system outside the area in which an airbag may be deployed if activated. (See Product
Mou nting D isclaimer Below)

•Keep these installation instructions with the product and readily available in the vehicle for future
refere nce of ot her use rs of the prod uct.

•Additional copies of the installation instructions can be obtained from Gamber-Johnson.
If you need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.

•Do not remove warning label from product under any circumstances.

INST-504

1. Remove front passenger side seat bolts and the
bolt and nut at the back of the passengers seat.
Disconnect wires under the passenger seat
and remove the passenger seat from the vehicle.

2. Remove trim pieces and rear seat bolts on the
drivers seat.

3. Remove nuts securing center seat/console
section.
Remove the center seat/console section.

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© copyright 2012 Gamber-Johnson, LLC

If y ou need assistance or have questions, call Gambe r-Johnson at 1-800-456-6868

1/2

4. Attach the Front Leg to studs which mounted
the front of the center seat/console section.
Place the Front Leg as shown with the bent edge
toward the front of the vehicle.

5. Slide one of the Back Legs under the
rear drivers seat bracket, reinstall seat bolt
but do not tighten.
Temporarily attach the other Back Leg using
the rear Passenger Seat Bolt, but do not tighten.
On vehicles with studs to mount the center
seat/console section reinstall the nuts,
but do not tighten.

6. Install the Top Plate using (6) .38-16 bolts
and washers supplied in hardware bag.
Adjust Back Legs so Top Plate is aligned
with center of vehicle.
Tighten all nuts and drivers side seat bolts.
Reinstall trim pieces on rear drivers seat
brackets.

7. Install Workstation and other
equipment to the Top Plate as required.
Complete the install by reinstalling the
passenger seat.

WARNING

• The components added to the Ford Super Duty Leg Kit should not be positioned in the area where the airbag
may be deployed if it is activated.

• DO NOT position the equipment in front of an airbag. Equipment positioned in front of an airbag may cause

serious injury or death if an airbag is activated.

•

High speed vehicle turns may cause the moving parts of the assembly to swivel, interfering with the driver or

other equipment.

• If installation of the equipment requires that the equipment be placed in front of an airbag, the airbag should be

deactivated. In order to secure permission for deactivating the airbag you must contact the National Highway
Traffic Safety Administration at 1-800-424-9393. If you have any questions or need assistance, call
Gamber-Johnson at 1-800-456-6868.

2/2