Gamber-Johnson 7160-0275 User Manual

INSTALLATION INSTRUCTIONS

Product Revision Form

7160-0275

Plate, Universal Display Mount

Rev.C

Printing Spec: PS-001

The Universal Display Mount Plate attaches to the Universal Display Mount (7160 -0272,
7160-0273). Refer to the installation instructions for the Universal Display Mou nt for
additional installation instructions.

The Universal Display Mount Plate accepts displays with the following mounting patterns:

- 75mm VESA - Motorola MW800/MW810

- 100mm VESA - Gamber Johnson 4.09"X2.00" Accessories

- Data911 Displays (15.0" & 12.1") with 7160-0302

Installation:

1. Install the display to the Plate using manufacturer recommended hardware.
a. The plate can be installed forward, backwards or upside down depending on
mounting requirements.

2. Using the supplied 1/4-20 hardware, install the plate into the slots in the Universal D isplay
Mount. Per the picture below, the Plate can be installed using either set of mounting holes

3. The plate can be installed using either the upper or lower set of holes depending on the
desired final mounting position.

VESA 75mm
VESA 100mm

INST-495

1/4-20 UNC

HARDWARE

ROBOVU

ROBOVU

ROBOVU FAN

CLEARANCE
GAMBER

4.02" X 2"

MOTOROLA

MW800/810

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the l ocation of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© copyright 2010 Gamber -Johnson, LLC

If y ou need assistance or have questions, call Gam be r-Johnson at 1-800-456- 6868

DISPLAY AT HIGHEST

DISPLAY AT LOWEST

RoboVu Installation:

If the attached, remove the RoboVu Standoff Bracket (Item 1).

1.

2. Install the Universal Diplay Mount Plate to the RoboVu Bracket using the 4 1/4- 20 x .5"
bolts and lock washers that were provided in the hardware bag. Note the Plate is installed
upside dow n and the fan cutout lines up with the fan exhaust.

3. Mount the assembly (plate and RoboVu) into the Universal Display Mount. Note that the
ears of Plate will face up.

FAN CLEARANCE

ITEM 1

REMOVE

ROBOVU FAN BRACKET

(PROVIDED WITH ROBOVU)

PLATE MOUNTED FOR ROBOVU