Gamber-Johnson 7160-0260 User Manual

INSTALLATION INSTRUCTIONS

Product Revision

7160-0260 Vehicle Base
FORD FUSION 2013+

Rev.C

Printing Spec:

Form

INST-487

PS-001

The purpose of this instruction sheet is to illustrate the manufacturer’s recommended

method of installing the Ford Fusion 2013+ vehicle base. The base requires no drilling.

Offset Riser

4X 3/8-16 x .75 Cap Screw

4X 3/8 Spring Lock Washer

4X 3/8 Flat Washer

Mounting Slots

Installation

Figure 1

1. Remove the seat bolts located at the front of the
passenger seat.

2. Loosen but do not remove the seat bolts at the
back of the passenger seat.

3. Orient the base with the bent flange towards the
front of the vehicle.

4. Slide the base between the seat legs and the
vehicle floor pan (see Figure 2).

5. Align the slots of the base with the mounting holes
on the seat and vehicle floor.

6. Re-insert the bolts that were removed in STEP 1.

7. Tighten all four (4) seat bolts securing the
passenger seat.

8. Secure the Offset Riser to the base.

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© Copyright 2013 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

Figure 2