Gamber-Johnson 7160-0249 User Manual

INSTALLATION INSTRUCTIONS

Product Revision Form #

7160-0249

Base - Chevy Co lorado/GMC Canyon - 2010+ - No Drill

WARNING

•You must read and follow all of these installation instructions. Failure to follow the
installation instructions may result in serious bodily injury or death.

•Do not install or use the 7160-0249 Assembly in the area in which the airbag on the
vehicle may be deployed. The installer and user of the 7160-0249 Assembly are
responsible for installing and using the 7160-0249 Assembly outside the area in which an
airbag may be deployed. (See Product Mounting Disclaimer Below)

•Keep these installation instructions with the product and readily available in the vehicle
for future reference of other users of the product.

•Additional copies of the installation instructions can be obtained from Gamber-Johnson.
If you need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.

•Do not remove warning label from product under any circumstances.

Rev A INST -478

Installed Colorado/Canyon Base

1. Remove the front in-board seat bolts from both Driver and Passenger seats.

2. Place the 7160-0249 Base on transmission hump and on top of the seat brackets.

3. Line-up the holes in vehicle base with holes in the seat brackets and re-insert the
seat bolts.

4. In applications where the 7160-0249 Base is used with the 7160-0114 Passenger
Side Base, longer bolts are required to replace the seat bolts, order Hardware Bag
7120-0504 seperately.

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaim s any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© copyright 2009 Gamber-Johnson, LLC

If y ou need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

WARNING

•The 7160-0249 Assembly should not be positioned in the area where the airbag may be
deployed.

•DO NOT position the equipment in front of an airbag. Equipment positioned in front of an

airbag may cause serious injury or death if an airbag is activated.

If installation of the equipment requires that the equipment be placed in front of an airbag,

•

the airbag should be deactivated. In order to secure permission for deactivating the airbag
you must contact the National Highway Traffic Safety Administration at
gain permission to do so. If you have any questions or need assistance, call
Gamber-Johnson at 1-800-456-6868.

•High speed vehicle turns may cause parts of the assembly to swivel, interfering with the

driver or other equipment.

1-800-424-9393 to