Gamber-Johnson 7160-0177 User Manual

INSTALLATION INSTRUCTIONS

Product Revision Form

7160-0177, 7160-0178

Center Upper Pol e Assemblies - 5" & 7"

The Center Upper Pole Assemblies are
used with any DS Lower Tubes or DS
Vehicle Bases with an integral low er tube.

REV. A

INST-412

Remove the (4) .25-20 x .75 Hex Head
Screws holding the upper bracket to the
tube.
Assemble the Motion Attachment device
being used to the upper bracket as shown,
using the hardwar e and bearing plates
supplied with the Mo tio n Atta ch m ent
device.
Adjust the drag on the swivel motion by
tightening the (3) .25 lock nuts as
required.
Reattach the upper bracket to the tube
with (4) .25-20 x .75 Hex Head Screws
and .25 Flat Washers.

Inse rt Center Upper Pole Asse mbly the
into Lower T ube or Vehicl e Base b eing
used .
While holding the Center Upper Pole
Assembly at the desired position, tighten
the center bolt securely with a 9/16"
open-end wrench.

Motion Attachment
(DS-Clevis)

Upper Bracket

Plastic Bearing

Plastic Bearing

Steel Backup
Plate

Tube

Two .3/8" dia holes, are provided as a
strain relief tie down points or for use
with a securit y cable.

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

If y ou need assistance or have questions, call Gambe r-Johnson at 1-800-456-6868