Gamber-Johnson 7160-0106 User Manual

INSTALLATION INSTRUCTIONS

Product Date Form #

90 DEGREE SIDE STEP

7160-0106

01/31/2008

WARNING

•You must read and follow all of these installation instructions. Failure to follow the
installation instructions may result in serious bodily injury or death.

•Do not install or use the 90 Degree Side Step Assembly (p/n 7160-0106) in the area in
which the airbag on the vehicle may be deployed. The installer and user of the 90 Degree
Side Step Assembly (p/n 7160-0106) are responsible for installing and using the 90 Degree
Side Step Assembly (p/n 7160-0106) outside the area in which an airbag may be deployed.
(See Product Mounting Disclaimer Below)

•Keep these installation instructions with the product and readily available in the vehicle
for future reference of other users of the product.

•Additional copies of the installation instructions can be obtained from Gamber-Johnson.
If you need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.

INST-365

MCS Top Plate

1. Attach the 90 Degree Side Step to
the MC S W ide T o p Plat e (p/n
7160-0085 or 7160-0086) using the
two .38-16 x .75 Hex Head Bolts and
two washers included in hardware
bag 7120-0093 as shown in FIG 1.

2. Attach the DS-Lower Pole using
the hardw a re prov ide d w ith the pol e.
Attach the desired DS-Upper,
Mo tion De vice, and Com puter
Docking Statio n or Cr adle as
desired.

DS-Lower Pole

.38-16 x .75

Hex Head Bolt

90v Side Step

FIG 1

Mounting the Side Step
to a wide top plate.

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

If y ou need assistance or have questions, call Gambe r-Johnson at 1-800-456-6868

Sht 1 of 2

90v Side Step

WARNING

•The 90 Degree Side Step Assembly (p/n 7160-0106) should not be positioned in the area where
the airbag may be deployed.

•DO NOT position the equipment in front of an airbag. Equipment positioned in front of an
airbag may cause serious injury or death if an airbag is activated.

•High speed vehicle turns may cause parts of the assembly to swivel, interfering with the driver
or other equipment.

•If installation of the equipment requires that the equipment be placed in front of an airbag, the
airbag should be deactivated. In order to secure permission for deactivating the airbag you must
contact the National Highway Traffic Safety Administration at 1-800-424-9393 to gain
permission to do so. If you have any questions or need assistance, call Gamber-Johnson at
1-800-456-6868.

Sht 2 of 2