Gamber-Johnson 7160-0101 User Manual

INSTALLATION INSTRUCTIONS

Product

7160-0101

LED ASSEMBLY

Rev.D

Printing Spec:

Form Revision

INST-431

PS-001

ATTACHING THE LED ASSEMBLY TO A DOCK:

STEP 1. Attach the LED Bracket to the dock with the two #6-32unc X 1/2" long
screws provided in the hardware bag. See Figure 1.

STEP 2. Attach the LED Assembly to the LED Bracket with the two #6-32unc X 1/2"
long pan head screws provided in the hardware bag. See Figure 2.

STEP 3. The LED is powered using the red and brown wires on the light base. It is
designed to operate on 12 VDC.

In a negative ground vehicle:
Connect the RED wire to the positive pole
of the battery or power distribution box. It
is recommended that the supplied fuse
holder and 1 amp fuse be installed on the
RED wire. Connect the BROWN wire to a
suitable chassis GROUND or the negative
pole of the battery.

The LED has three light options: Red,
Red and White, and OFF.

LED Assembly

Figure 2

#6-32unc X 1/2" Screws

Figure 1

#6-32unc X 1/2" Screws

Product Mounting Disclaimer

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

© Copyright 2013 Gamber-Johnson, LLC

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868