Gallien Krueger Backline 250, Backline 115, Backline 600 User Manual

Backline 350
Owner’s Manual
Backline 250
Backline 600
Backline 115
Backline 210
1
Backline SeiesBackline Seies
Backline Seies
Backline SeiesBackline Seies
Table Of Contents
Table of Contents
Introduction.....................................................................
Safety Information..........................................................
Quick Start.......................................................................
Settings & Sounds............................................................
Sound Tips.......................................................................
Front & Rear Panel Controls........................................
Installation & Maintenance..........................................
Backline Combo............................................................
Tech Talk........................................................................
Specifications.................................................................
*All Features and specifications are subject to change without notice
**This list is subject to change without notice.
Please read the Safety Information section on page 5 before continuing.
IMPORTANT SAFETY INSTRUCTIONS.
3 4 5 6
7 8 10 11 12 13
.
2234 Industrial Drive Stockton, CA 95206 phone: 209-234-7300 fax: 209-234-8420 www.gallien-krueger.com
2
Backline SeriesBackline Series
Backline Series
Backline SeriesBackline Series
Congratulations
Your purchase of a new Gallien-Krueger Backline product is surely the result of much careful consideration on your part. For our part, we at Gallien-Krueger are pleased that you chose us, and are determined that you will be a satisfied customer. In choosing a Backline product, you now own an amplifier with many unique features, which will allow you to create your own distinct sound.
To get the most out of your new purchase please take a few minutes to read through this manual. If you are in a hurry, we suggest you at least read through the Quick Start and Safety Information sections before setting up your new rig. This will help get you started and give you a few quick tips, but is not a substitute for reading the rest of the manual.
Your Backline unit should have come with the following items, please check the contents of the box to ensure that you have everything.
Included with your Backline 350/250/600 Head:
Backline 350/250/600 1 Power cord 1 Owner’s manual 1 Warranty card 1 Safety instructions sheet 1
GK Philosophy
I have never seen the point in doing things the way others have done them. I also have not been very interested in following the latest fad. I am a Stanford educated engineer who worked his way through school as a musician. Like all musicians, I have lugged amplifiers up stairways and into car trunks, always wondering why these things had to be so heavy, bulky, and hard to handle. As I am the principal innovator at reflect my attitudes and life experiences. I don’t model my designs after other manufacturer’s products (as some of our competitors are proud of reciting). Instead, I believe new and old problems are best solved with new solutions. Having taken our own path, enjoy a unique, unmatched sound, allowing the artist using them every opportunity to make an original statement. Having supported my products for over thirty years, I have learned from the story they tell. KruegerKrueger
Krueger is a reflection of that story, and has a commit-
KruegerKrueger ment to support that legacy. Just as the products I created thirty years ago are still telling their story, the products we create today will be talking to us tomorrow. We’ll be listening,
GKGK
G K, our products
GKGK
GKGK
G K products
GKGK
Gallien-Gallien-
Gallien-
Gallien-Gallien-
Introduction
Included with your Backline 210/115 Combo: Backline 210/115 1 Power Cord 1 Owner’s Manual 1 Warranty Card 1 Safety Instructions Sheet 1
If your new unit did not come with all the items listed, or if you encounter problems while setting up your new equipment, please contact your local dealer, or GK customer service at: Gallien-Krueger, Inc. 2234 Industrial Drive Stockton, CA 95206 phone: (209) 234-7300 fax: (209) 234-8420 Internet: www.gallien-krueger.com Email: sales@gallien.com We wish you a lifetime of good playing and remember to always have fun!
Robert Gallien
Founder & President
3
Safety Information
Backline SeriesBackline Series
Backline Series
Backline SeriesBackline Series
Safety Information
Verify Line Voltage and Amperage Before Use:
Your new Backline unit has been factory configured for use with:
. . .
Proper AC circuit for all other countries. Connecting the amplifier to a line with specifications other than indicated above can create a safety and fire hazard, and may damage the amplifier. If you have any questions about the voltage requirements for your specific model, or about the line voltage in your area, contact your dealer before plugging the unit into a wall outlet.
Verify AC Circuit Capacity Before Use:
The high power output of your amplifier may require heavy current draw under Full-Load conditions. To insure proper performance and avoid potential safety hazards, we recommend connection to line circuits with Amperage specified as above. Connecting multiple amplifiers to the same circuit, or connecting the amplifier to the same circuit used by other heavy-power devices, such as high­wattage lights, may cause circuit breakers to trip. It is always a good idea to avoid using any audio equipment on the same AC circuit as equipment with motors, such as air conditioners or refrigerators. This will lessen to possibility of power variation and electrical start-up noise affecting your sound.
Warning: Do not disconnect or plug in the instrument/speaker cable with the amplifier power on. Be sure the amplifier unit is turned off before connecting anything to it.
120 Volt/60Hz 15 Amp circuit for USA & Canada. 230 Volt/50Hz 10 Amp circuit for Europe & Australia. 100 Volt/50Hz 15 Amp circuit for Japan.
Do Not Use Extension Cords:
To avoid safety hazards, use only the power cord supplied with your unit. If a replacement cord is used, make certain that it is of consistent quality and gauge as the original. We do not recommend using extension cords with this product. As with all electrical devices, do not run power cords under rugs or carpets or place heavy objects on them. Damaged power cords should be replaced immediately with cords meeting factory specifications.
Handle The AC Power Cord Gently:
When disconnecting the power cord from an AC outlet, always pull the plug, never pull the cord. If you do not intend to use the amplifier for a considerable length of time, disconnect the plug from the AC outlet.
Mains Disconnect:
If the AC mains has to be completly disconnected, the plug/power cord is used as the mains disconnect device and shall remain readily operable.
Do Not Open The Amplifier Enclosure:
There are no user-serviceable components inside this product. Opening the amplifier enclosure may present a shock hazard, and modification to the product will void your warranty. If liquid enters the unit, or any metal object such as a paper clip, wire, or staple accidentally falls inside the enclosure, disconnect the unit from the AC power source immediately and consult an authorized service station.
Unpacking:
The carton and packing materials used in shipping your new amplifier were specially designed to cushion it from the shocks and vibration that occur during transport. We suggest that you save the carton and packing materials for use in shipping, in the event you move, or the amplifier needs repair.
4
Quick Start
Backline SeriesBackline Series
Backline Series
Backline SeriesBackline Series
Your Backline unit is designed to be simple to operate. All controls have a well defined purpose and are well behaved. These directions will take you through the basics and give you a good start for setting up your sound.
1.
Set the power switch to Off and connect the supplied power cord from the amplifier AC receptacle to an AC power outlet of proper voltage and power rating (see safety information on page 5 for details).
2. (Backline 350/250/600 Only)
Connect your speaker cabinet to the amplifier output marked 175W/125W/300W. Be sure not to go below the recommended speaker load listed below. Take note also that the speaker cabinets power capacity must be equal or higher than the ouput power of the unit.
Minimum Recommended Speaker Load:
One 4 0hm or two 8 ohm cabinets or One 8 ohm cabinet
Backline 350Backline 350
for
Backline 350 and
Backline 350Backline 350
Backline 600.Backline 600.
Backline 600.
Backline 600.Backline 600.
not turn the volume control in the input section past 1 oclock unless you want an overdrive effect. If you have a bass with passive electronics make sure that the controls on the bass guitar are all the way up. If you have a bass with active electronics, set all controls on the bass to the middle or flat position.
At This Point:
You should be hearing your bass quite well. You can use the volume and Master to achieve a comfortable sound level.
5.
Now you are ready to check out the overdrive feature (Channel-B). Push in the Level A/B button. The over­drive LED should light. Set the Gain control to 9 oclock as a starting point. Slowly raise the Level-B volume to the desired sound level. This will give a slightly distorted sound. Raising the gain will add more distortion and sustain. (See Sound Tips for more detail).
Quick Start
Backline 250 Backline 250
For
Backline 250 minimum load impedance is 8 Ohm,
Backline 250 Backline 250 that will translate to one 8 Ohm cabinet or two 16 Ohm cabinet.
If you are using a crossover switch to full range.
Backline 115Backline 115
For
Backline 115 and
Backline 115Backline 115 load impedance is 4 ohms. With the internal cabinet connected, the minimum impedance of an external speaker cabinet that can be connected is 8 ohms
3.
Set all EQ controls and the Boost control to 12 oclock. The Voicing Filter should be turned all the way down to get a flat response. Set the Gain, Level-A, Level-B and Master Volumes at 0. Set the A/B switch to off (Channel A).
4.
Using an instrument cable, connect your bass to the Input jack and turn the power switch on, set the master control to 3 oclock, slowly bring the Level-A volume up and play. If the clip LED flashes excessively, push the button marked
--
-10db in. Occasional clip light flashes while playing very
-­hard, is normal and should not raise any concern . Do
GK RBH/SBXGK RBH/SBX
GK RBH/SBX series cabinet, set the
GK RBH/SBXGK RBH/SBX
Backline 210Backline 210
Backline 210, The minimum
Backline 210Backline 210
Characteristics of the Backline:
The Backline Series are flexible, user-friendly state-of-the­art bass series, designed to deliver maximum perfor­mance. This is accomplished through these important features:
.
Extremely high current power supply and
power amp circuitry, gets the sound out of your head.
Four bass specific bands of active equalization
.
for Precise tone control.
.
An adjustable voicing filter for shaping and customizing your sound.
Balanced direct output eliminates the need for
.
a direct box.
Bass specific overdrive channel for all
.
modern sounds.
5
Loading...
+ 11 hidden pages