power amplifier. When used properly, these features will give
you the most exciting bass sound available today. A careful
will not effect any signal put into the return jack. The level is
upper set is for the 100W power amp and in the bi-amp mode
115V operation - replace with Type 3AG7A
230V operation - replace with Type 3AG4A
your Bass before adjusting the EQ on your amp.
volume and boost levels while dropping back the masters. This
will give a fatter sound but can add distortion. Some players find
possible sound, operate the masters near or on "10" (max). The
boost control is footswitchable and can act as a preset volume.
relative levels of the high and low masters. It is best to adjust
mellow round sound. Hi Boost adds edge and definition.
your tone. This is an involved procedure requiring you to use
your ears to tell you what is right. We have broken the sound
After you have adjusted the Eq, you may want to fine tune the
: Boost and cut at 4KHz, will add or remove edge and
: Boost and cut at 1KHz. There is a lot of sound in
: Boost and cut at 250Hz. Basically, this band
: Boost and cut at 60Hz. Effects only the bottom end and
will be used to account for varying room acoustics.
Sensitivity 2mv rms
Max Level 1V rms
Impedance 1M ohm
Sensitivity 6mv rms
Max Level 3V rms
Impedance 1M ohm
Level(Boost off) 1.5V rms
Impedance 100k ohm min
Level 500mv rms
Impedance 600 ohm
8 ohm 100w
16 ohm 60w
8 ohm 200w
4 ohm 300w
Switch to ground, 15dB Max
23 lbs.
5¼''height x 17¼'' width x 9 ½'' depth
US: (209) 234-7300 • FAX (209) 234-8420
Loading...