GAI-Tronics XSA2000A User Manual
Pub. 43003-027B
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
Model XSA2000A Conversion Kit
ITA2000A to ITA2000S
Field Installation Kit Instructions
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model XSA2000A Conversion Kit provides the equipment necessary to convert a standard Model
ITA2000A Tone Remote Adapter to a Model ITA2000S Scanning Tone Remote Adapter. This kit
includes the following components:
Qty Description
1 EPROM, 50086-079
1 Label, 25326-094
1 Pub. 43004-018A, ITA2000S Installation and Service Manual
Installation
Proper grounding is advised.
1. Remove the 4 screws holding the cover of the Model ITA2000A in place. Remove the cover.
2. Extract the EPROM (U2) from the PCBA. See Figure 1 for the location.
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 800-492-1212 Fax: 610-796-5954
VISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
Pub. 43003-027B
Model XSA2000A Conversion Kit – ITA2000A to ITA2000S Page: 2 of 2
3. Replace it with the EPROM provided in this kit taking care to observe the direction indicated on the
socket and the EPROM. Ensure the pins are seated and not bent. Make sure the connectors fit
properly into the cover.
4. Replace the cover and secure it with the four screws.
5. Carefully apply the label supplied with this kit onto the front of the tone adapter in the position shown
in Figure 1.
Figure 1.
\\s_eng\gtcproddocs\radio products-draft\gtc 4300x\43003-027b\43003-027b.doc
09/04
Loading...