GAI-Tronics XCP0500A User Manual

Pub. 43003-041A

GAI-TRONICS® CORPORATION

A HUBBELL COMPANY

Model XCP0500A Handset Base Kit

Field Installation Kit Instructions

Confidentiality Notice

This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.

General Information

The Model XCP0500A Handset Base for the ICP9000 Series Desktop Console or the ICP9000 Navigator
Series MCU allows for a connection of a remote push-to-talk handset. The kit includes the following
components:

Qty Description

1 Handset Base assembly with Handset

Installation

ICP9000 Series Desktop Console

1. Plug the modular connector into the rear of the console at the HEADSET/HANDSET jack.

2. Route the connection wire behind or under the console based upon the location of the handset base.

GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA

610-777-1374  800-492-1212  Fax: [phone]

VISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS

Pub. 43003-041A

Model XCP0500A Handset Base Kit Page: 2 of 2

Figure 1. Handset Base Assembly

ICP9000 Navigator Series MCU

1. Remove the rear panel.

2. Remove the Navigator control ribbon cable from the PPI on the Navigator board and PPI on the main

board. Keep the cable for future use.

3. Position the shorting clips on PP2 to enable operation of the handset. This option must also be

enabled and the sensitivity of the handset/headset microphone set in the User Parameter Menu as
described in the Console Diagnostics section of the Installation and Service Manual, Pub 43004-025.

4. The handset jack plugs into the modular-styled

MCU.

N

OTE: This jack is not labeled on this product.

N

OTE: The Model XAAB002A Audio Accessory Box can also be used for the Navigator application.

This will eliminate the need to access the inside of the MCU.

HEADSET/HANDSET jack (P9) at the back of the

09/05