GAI-Tronics XCP0300A User Manual

Pub. 43003-031D

GAI-TRONICS® CORPORATION

A HUBBELL COMPANY

Model XCP0300A

Navigator Upgrade Kit

Field Installation Kit Instructions

Confidential ity Notice

This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.

General Information

The Model XCP0300A Upgrade Kit for the ICP9000 Navigator consoles includes the firmware and
software necessary for upgrading to the current production features and functionality. This kit is intended
only for use in the ICP9000 Navigator Series MCU. It includes the following components:

Qty Description

1 Master EPROM chip
1 Host EPROM chip
3 Slave EPROM chips
1 Navigator Software CD
1 Programming Bundle CD (includes CARD Suite Software)
1 Navigator Installation/Service Manual

GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA

610-777-1374  800-492-1212  Fax: [phone]

V

ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS

Pub. 43003-031D

Model XCP0300A Navigator Upgrade Kit Page: 2 of

Installation

ICP9000 Navigator Series MCU

1. Disconnect power from the ICP9000 Navigator Series MCU and remove all attached cables from the

rear panel.

2. Remove the 10 screws securing the side cover panel and gently lift the cover off. See Figure 1.

3. On each slave PCBA (CP-CSD) locate U502 EPROM socket and extract the EPROM.

4. Replace them with the Slave EPROM (SLAV**) provided in this kit, taking care to observe the

direction indicated on the socket of the EPROM. Ensure that the chip is properly seated in the socket.

5. Disconnect the ribbon cables (SLV-CBL-M) attached to the Main PCBA.

3

6. Remove the 4 screws holding the inner PCBA mounting plate to the main enclosure.

7. Disconnect the (SLV-CBL-P) cables from the surge suppression PCBAs. This allows you to remove

the inner PCBA mounting plate to gain access to the main PCBA. Refer to Figure 1.

f:\radio products-draft\gtc 43003\43003-031d\43003-031d.doc
12/10

Figure 1.