GAI-Tronics XCP0020A User Manual

Pub. 43003-013B

GAI-TRONICS® CORPORATION

A HUBBELL COMPANY

XCP0020A 16-Frequency Control Kit

Field Installation Kit Instructions

Confidentiality Notice

This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.

General Information

The Model XCP0020A 16-Frequency Control Kit includes the following components:

Qty Description

1 SEL Button
1 HOME Button
1 UP Button
1 DOWN Button

Installation

NOTE

1212. Select the prompt to speak to a radio products service technician. Have your order number
available to verify your purchase. Also, be in front of the console to receive and enter the activation
codes.

1. Remove the existing blank buttons from the F1 through F4 button locations on the front panel and

replace with the buttons included in this kit. Refer to Figure 1 for the location of the buttons to be
replaced.

2. To remove a button, use needle-nose pliers to grasp the top and bottom as close to the base of the

button as possible without scratching the console. Squeeze in at the top and bottom points and gently
pull the button out.

To enable the 16-frequency option, you must first contact GAI-Tronics at (800) 492-

GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA

610-777-1374 n 800-492-1212 n Fax: [phone]

VISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS

Pub. 43003-013B

XCP0020A 16-Frequency Control Kit Page: 2 of 2

3. To install a button, use needle-nose pliers to squeeze in at the top and bottom of the button. Slide the

button into the appropriate place on the key panel until it snaps into place.

4. Please refer to your ICP9000 Series Desktop Console Operator’s Manual, 43004-016, for further

information. The GAI-Tronics CARD Suite Software (XAC1000A) contains the necessary
information for configuration of this option in your ICP9000 Series Desktop Console. You must
“read console” after activation to be able to enter more than the standard 4 frequencies per channel.

4/02

Figure 1.