GAI-Tronics 12586-002, 12586-003, 12586-004 User Manual
Pub. 42003-137A
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
Harness A ssembly Replacement Ki t
MODELS 12586-002, 12586-003, AND 12586-004
Confidentiality Notice
This manual is pr ovided s olely as a n op erat ional, installation, and maintenance guide and contains sens itive
bus ines s and t echnic al infor ma tion which is conf idential and propriet ary to GAI-Tronics. GAI - Tronic s
retains a ll intellectual pr operty and other rights in or to t he inf ormation c ontained herein, and s uch
informa tion may only be used in connection wit h the operation of you r GAI- Tronic s pr oduct or system.
This ma nual may not be disclosed in any form, in whole or in p art, dir ec tly or indirectly, to any t hird pa rty.
General Information
This ma nual s upplies inf ormation for the following kits:
Kit Number Intended for use with:
12586-002 Indoor stat ions
12586-003 Weatherproof stations made of cast aluminum
12586-004 Weatherproof stations made of glass-reinforced polyester
CAUTION
Each kit is designed to mate with a specific enclosure material. Do not interchange equipment.
Failing to install a kit with the correct enclosure could jeopardize the integrity of the connection
between the amplifier and the enclosure.
This kit includes the following components:
Qty Description
1 Harness Assembly
2 Screw
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 800-492-1212 Fax : 610-796-5954
ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
V
Pub. 42003-137A
H
ARNESS ASSEMBLY REPLACEMENT KIT Page: 2 of 2
Installation
Indoor Enclosure (Model 12586-002)
1. Remove and discard the harness a ssembly (TB1), the
connector (J1), and the a ssociated hardware. See Figure 1.
OTE: Do not remove TB2 .
N
2. Ins tall the h arness assemb l y pla te by alig n i n g the p l at e wi th th e
holes used to mount the previous TB1. Secure the assembly
using the 2 screws included in the kit.
Weatherproof Enclosures (Models 12586-003
and 12586-004)
1. Remove the label on the front c over of the enclos ure, and discard it.
2. Remove and disc ard the har ness a ssembly (TB1), the connector (J1), and t he associat ed hardware. See
Figure 2 a nd Figure 3.
OTE: Do not remove TB2 .
N
3. Ins ta l l the harn ess assembly plate b y alig n i n g the p l at e wi th t he h o l es used to mount the p revious TB1.
Secur e the a ssemb l y usi ng the 2 screws in cluded i n the kit.
Figure 1. Indoor Enc l osur e
Figure 2. W eather proof Enclosu re
Glas s Reinfor c ed Polyester
\\s_eng\gtc proddoc s \ s tandard ioms - current release\ 42003 k it m anuals \42003-137a.doc
2/97
Figure 3. W eather proof Enclosu re
Cast Aluminum
Loading...