GAI-Tronics 12567-001 User Manual
Pub. 42003-084A
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
Page Button Replacement Kit
Model 12567-001
Confidential ity Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model 12567-001 Push Button Replacement Kit is provided for use on the Model 491-204 Mine
Dial/Page Telephone, and includes the following com ponents:
Qty Description
1 Button Assembly
2 Switch Block
1 Switch Mounting Adapter
Removing the Old Button
1. Unscrew the lock ring securing the page button to the front cover of the mine phone.
2. The page button will be loose. Open the door of the telephone, and feed the button through the back
of the door.
3. Use a screwdriver to loosen the screws securing the wires to the two switch blocks.
4. Remove the wire connections from the switch block.
5. Discard the old page button and the lock ring.
Installing the New Button
1. Attach the button to the door first.
2. Feed the button through the front of the door, and secure it using the supplied plastic nut.
3. Attach the switch-mounting adapter by aligning the slots with the grooves on the back of the button.
Turn the locking lever to secure the adapter to the button.
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374 800-492-1212 Fax: 610-796-5954
V
ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
Pub. 42003-084A
ODEL 12567-001 PUSH BUTTON REPLACEMENT KIT Page: 2 of 2
M
4. See Figure 1 for proper wiring and switch block orientation. Connect the wires removed from the old
switch to the new switch blocks.
5. Connect the jumper wires as noted in Figure 1.
6. Tighten the screws to secure the wires firmly to the switch blocks.
7. Attach the switch blocks by snapping them onto the switch-mounting adapter. Pay careful attention
to the proper placement of each switch block per Figure 1.
8. Close the unit.
.1
44-131eao esa
.2
.3
(TEXT SIDE)
.4
.3
.4
.1
.2
Figure 1.
f:\standard ioms - current release\42003 kit manuals\42003-084a.doc
04/10
Loading...