GAI-Tronics 12550-001 User Manual
Pub. 42003-061C
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
Page/Party® Receiver Replacement Kit
Model 12550-001
Confidentiality Notice
This manua l is provide d sole ly as an operatio nal, installation, and ma inte nance guide and conta ins
sensitive business and t e chnical informatio n tha t is confidentia l and pr opri et ary to GAI- Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manu al may not be dis clos e d in any form, in whole or in pa rt, direct ly or i ndir ectly, to a ny
third pa r ty.
General Information
The Model 12550-001 Page/Party® Receiver Replacement Kit is for use on Page/Party® 701-20x Series
Amplifiers. This kit includes the following components:
Qty Description
1
1
Handset Printed C ircui t Board As semb ly
Ha n d set R eceiver
Installation
Removal of old receiver
1. Unscrew receiver cap.
2. Remove receiver assembly from handset. Unplug red wire from the printed circuit board.
3. Loosen screw securing green wire and disconnect wire.
4. Discard old receiver assembly.
GAI-Tronics Corporation P.O. Box 1060, Readi ng, PA 19607-1060 USA
610-777-1374 800-492-1212 Fax: 610-796-5954
ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
V
Pub. 42003-061C
M
ODEL 12550-001 PAGE/PARTY® RECEIVER REPLACEMENT KIT Page: 2 of 2
Installation of new receiver
1. Place receiver on a flat surface with the varistor facing down.
2. Remove the two screws in the receiver.
3. Place the board on the receiver with the antenna pointing up, away from the varistor.
4. Screw the board to the receiver with the green wire under the left screw where indicated.
5. Attach the red wire to the standoff in the center of the board.
6. Bend the silver antenna so that it is flat against the side of the receiver. Then bend the small end
around the corner so it is tight against the front of the receiver.
7. Hold the handset handle in the vertical position (receiver cavity at the top). Install the receiver
assembly into the cavity with the silver antenna bar at the five o’clock position.
8. Tighten the receiver cap.
\\s_eng\gtc proddoc s \st andard iom s - current release\42003 kit manuals \ 42003-061c . doc
02/01
Loading...