GAI-Tronics 12531-001 User Manual
Pub. 42003-087
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
Wire Ha rness Replacement Kit
Model 12531-001
Confidentiality Notice
This manua l is provide d sole ly as an operatio nal, installation, and ma inte nance guide and conta ins
sensitive business and t e chnical informatio n tha t is confidentia l and pr opri et ary to GAI- Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manu al may not be dis clos e d in any form, in whole or in pa rt, direct ly or i ndir ectly, to a ny
third pa r ty.
General Information
The Model 12531-001 Wire Harness Replacement Kit is designed for the GAI-Tronics Models 13350 and
13351. This kit includes the following components:
Qty Description
1 Quick-connect receptacle/connector harness assembly, 4-wire (for use with Model 13350 only)
1 Harness assembly with quick-connect receptacles, 2-wire (for use with Model 13351 only)
Installation
In the Model 13350 Only
1. Loosen the six front panel captive screws.
2. Gently pull the front panel of the speaker away from the rear enclosure. Disconnect the two quick-
connect receptacles from the rear enclosure terminal block.
3. Lay the speaker front panel on a flat surface. Remove the two quick-connect receptacles from the
speaker. Discard the old harness assembly.
4. Install the new harness assembly by connecting the black wire receptacle to the speaker terminal with
the red mark. Connect the white wire receptacle to the other speaker terminal.
5. Connect the wires to the rear enclosure terminal block terminals, following the wiring guidelines on
the terminal block label.
6. Align the speaker front panel with the rear enclosure. Tighten the front panel screws to 16–20 in-lbs.
torque.
GAI-Tronics Corporation P.O. Box 1060, Readi ng, PA 19607-1060 USA
610-777-1374 800-492-1212 Fax: 610-796-5954
ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
V
Pub. 42003-087
M
ODEL 12531-001 WIRE HARNESS REPLACEMENT KIT Page: 2 of 2
In the Model 13351 Only
1. Loosen the six front panel captive screws.
2. Gently pull the f ro nt panel of the s peaker away f rom the rear en clo sure. Un plug t he w i re harness
connector l oca ted below the sp eak er.
3. Lay the speaker front panel on a flat surface. Remove the quick-connect receptacle from the rear
encl osure terminal block. D i scard the old ha rness assembly.
4. Install the new harness assembly by connecting the quick-connect terminals to the rear enclosure
terminal block terminals matching the terminal block label designations as follows: black: COM;
yellow: 3.7 W; orange: 7.5 W; red: 15 W.
5. Plug the wire harness connector into the connector located below the speaker.
6. Align the speaker front panel with the rear enclosure. Tighten the front panel screws to 16–20 in-lbs.
torque.
\\s_eng\gtc proddoc s \st andard iom s - current release\42003 kit manuals \ 42003-087. doc
1997
Loading...