GAI-Tronics 12530-002 User Manual

Pub. 42003-041A

GAI-TRONICS® CORPORATION

A HUBBELL COMPANY

Transformer/Connector Subassembly Ki t

Model 12530-002

Confidentiality Notice

This manua l is provide d sole ly as an operatio nal, installation, and ma inte nance guide and conta ins
sensitive business and t e chnical informatio n tha t is confidentia l and pr opri et ary to GAI- Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manu al may not be dis clos e d in any form, in whole or in pa rt, direct ly or i ndir ectly, to a ny
third pa r ty.

General Information

The Model 12530-002 Transformer/Connector Subassembly Kit is provided for use on Model 701-203.

Installation

Removal of Old Subassembly

1. Remove the amplifier from the enclosure by loosening the four front panel screws.

2. Using a hex nut driver, lo osen t he 4 screws ( two are on the top surfa c e of the u nit a nd two a re on the

bottom) holding the front panel to the chassis.

3. Separate the chassis from the front panel of the amplifier.

4. Locate the transformer by the first locating the white connector on the upper right corner of the

PCBA. The transformer has five wires connecting it to the connector: black, green, yellow, blue and
brown.

5. Remove the two self-tapping screws on the top of the amplifier.

6. Unplug the connector from the PCBA and remove the transformer/connector subassembly.

GAI-Tronics Corporation P.O. Box 1060, Readi ng, PA 19607-1060 USA

610-777-1374  800-492-1212  Fax: [phone]

ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS

V

Pub. 42003-041A

M

ODEL 12530-002 TRANSFORMER/CONNECTOR SUBASSEMBLY REPLACEMENT KIT Page: 2 of 2

Installation of New Subassembly

1. Plug the new connector onto the PCBA. The connector plugs in only one way – do not force it.

2. Align the holes of the transformer with the holes on the top of the amplifier.

3. Insert and tighten the two self-tapping screws.

4. Tighten the four screws to secure the chassis to the front panel of the amplifier.

5. Place the amplifier in the enclosure.

6. Tighten the four front panel screws to secure the amplifier.

\\s_eng\gtc proddoc s \st andard iom s - current release\42003 kit manuals \ 42003-041a.doc
1990