GAI-Tronics 12514-30X User Manual

Pub. 42003-265A

GAI-TRONICS® CORPORATION

A HUBBELL COMPANY

Handset Kit for

®

ExICS Page/Party

Model 12514-30x

Confidential ity Notice

This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.

Stations

General Information

The Model 12514-30x Handset Kit is designed to replace the PVC or Hytrel® coil cord assembly in
ExICS Page/Party

This kit includes the following com ponents:

Qty Description

1 Handset assembly with 6-foot PVC coil cord & bushing (Model 12514-301 Kit only)
1 Handset assembly with 15-foot PVC coil cord & bushing (Model 12514-302 Kit only)
1 Handset assembly with 25-foot PVC coil cord & bushing (Model 12514-303 Kit only)
1 Handset assembly with 6-foot Hytrel
1 Handset assembly with 15-foot Hytrel
1 Handset assembly with 25-foot Hytrel
1 Red fiber washer for bushing
3

®

stations.

Screw, 6-32  5/16-inch PHMS

®

coil cord & bushing (Model 12514-304 Kit only)

®

coil cord & bushing (Model 12514-305 Kit only)

®

coil cord & bushing (Model 12514-306 Kit only)

Installation

WARNING

power from the station.

Before performing any of the following settings and adjustments, remove all

WARNING

supply circuit before making any adjustments to the amplifier’s handset level.

GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA

To reduce the risk of hazardous atmospheres, disconnect the equipment from the

610-777-1374  800-492-1212  Fax: [phone]

V

ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS

Pub. 42003-265A

ODEL 12514-30X HANDSET REPLACEMENT KIT FOR EXICS PAGE/PARTY® STATIONS Page 2 of 4

M

Opening the Station

Remove all cover bolts from the enclosure. Swing the front door open to access the internal PCBAs. See
Figure 1.

Figure 1. ICS Hazardous Area Station – Interior View

Installing the New Handset Assembly

1. Unplug the handset barrier from the handset barrier cable assembly.

2. Remove the two screws holding down the handset barrier.

3. Carefully rotate the handset barrier to the side to access the handset wires inside of the barrier.

Unscrew the wires on the terminal block inside of the barrier and remove the four attached wires.

4. On the front of the enclosure, remove the screw preventing the coil cord bushing from rotating.

5. Unscrew the handset coil cord bushing from the front of the enclosure.

e:\standard ioms - current release\42003 kit manuals\420 03-265a.doc
11/13