GAI-Tronics 12513-002 User Manual

Pub. 42003-025C

GAI-TRONICS® CORPORATION

A HUBBELL COMPANY

Valox® Enclosure Mid/Rear Secti on Kit

Model 12513-002

Confidentiality Notice

This manua l is provide d sole ly as an operatio nal, installation, and ma inte nance guide and conta ins
sensitive business and t e chnical informatio n tha t is confidentia l and pr opri et ary to GAI- Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manu al may not be dis clos e d in any form, in whole or in pa rt, direct ly or i ndir ectly, to a ny
third pa r ty.

General Information

This kit services the following models: Model 256-001, 256-001SK, 257-001, and 272-001. This kit
includes the following components:

Qty Description

1 Weather proof Enc losure (mid-s e c tio n)
1 Weatherproof Enclosure (rear section)
4 Screw

Remo ving the F ront Panel Assembly

1. Remove the four screws from the front panel assembly. Pull the front panel assembly approximately

6 to 8 inches away from the back enclosure.

2. Disconnect the modular telephone line cord from the PCBA, and completely remove the front panel

assembly.

Remo ving the Door

1. Open the enclosure door.

2. Loosen the two screws to the upper hinge half on the mid-section, and remove the hinge and door.

GAI-Tronics Corporation P.O. Box 1060, Readi ng, PA 19607-1060 USA

610-777-1374  800-492-1212  Fax: [phone]

ISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS

V

Pub. 42003-025C

M

ODEL 12513-002 VALOX ENCLOSURE MID/REAR SECTION REPLACEMENT KIT Page: 2 of 2

Remo ving the Mid/R ear Section

1. Loosen the four screws located in the corners of the inside mid-section of the enclosure.

2. Swing the mid-section away from the rear section to access the rear mount screws.

3. Loosen the bushing nut inside the enclosure at the bottom.

4. Remove the nut, and pull the modular telephone line cord out of the assembly. Put aside the old

bushing and bushing nut.

5. Loosen the four screws fastening the enclosure to the wall, and remove it.

Installing the New Mid/Rear Section

1. With the mid-section swung out of the way, align the rear section with the mounting holes in the wall,

and fasten it using the same screws/bolts that were used previously.

2. Insert the previously used bushing in the bottom of the new enclosure. Insert the modular telephone

line cord through the bushing and enclosure, and fasten them with the previously used bushing nut.

3. Swing the mid-section back against the rear section, and fasten it with the four screws provided.

4. Reconnect the modular telephone line cord to the printed circuit board of the front panel assembly.

5. Fasten the front panel assembly to the mid-section of the new enclosure.

6. Mate the bottom hinge of the door with the bottom hinge of the mid/rear section of the enclosure.

7. Alig n the l oose upper hinge wit h the sec ure h inge on the e nclos ure, and fasten it.

\\s_eng\gtc proddoc s \st andard iom s - current release\42003 kit manuals \ 42003-025c . doc
04/06