Fuzhou Emax Electronic 1212, 1213 User Manual

STG-1213 Manual

FCC COMPLIANCE

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.

BATTERY PRECAUTIONS

Dispose of old batteries properly. Do not dispose of old batteries.
Do not leave batteries lying around where a young child or pet could
play with or swallow them. If batteres are swallowed，contact a physician

immediately.
Batteries may explode if mistreated. Do not attempt to recharge or
disassemble batteries.

SAVE THESE INSTRUCTIONS

SMARTFIND OPERATION

Installing Batteries
Key Ring Receivers
Each key ring receiver uses one CR2032 button cell battery
(included).

1. Use a small precision screwdriver to remove the screw on the back of
the receiver. Remove the battery cover.

2. Install the supplied battery into each key ring receiver, ensuring
the '+' side of the battery is facing up.

Using the Key Ring Receiver

The SmartFind Personal Item locator has two key ring receivers.
Each receiver is color- and number-coded to match a corresponding

STG-1213 Manual

Transmitter

battery: 2 AAA 1

.5 volts

(not included).

button on the transmitter.

1.Attach keys to color-coded key ring receivers.

2. press and hold the appropriate color-coded button on the
transmitter for five seconds.

3. If the key ring receiver is in range (60 feet), it emits an audible
beep.

4. If no beep is heard. change your location and press and hold the
color-coded button again for five seconds.

Attaching the Slim Receiver

The SmartFind Personal Item Locator also has two slim receivers.
Each slim receiver is color and number-coded to match a
corresponding button on the transmitter. The slim receivers can
easily be attached to many common household items,such as a cell
phone. TV remote control. PDA, eyeglass case or wallet,using the
included double-sided tape.

1. Remove paper cover from one side of the double-sided tape
strip.

2. Insert sticky side of the tape strip into the recessed cavity located
on the back of the slim receiver. Press firmly for five seconds to
securely attach.

3. Remove paper cover from the other side of the tape strip.

4. Press firmly against the item.

SPECIFICATIONS

Range:60 feet ,key ring receiver/60 feet ,slim receiver.
Loudness: 80dB@1 inch
Broadcast frequency: 433.92 MHz
Receivers battery. CR2032 3V (inducted)
Slim Finder battery: CR2032 3V (included)