Futuro Futuro WL36SHADE, WL39MURFORTUNALED, WL27MURMETROLED, WL27MURNEWYORKLED, WL24STREAMLINEWHT Control Panel Function

G

OPERATION

1. TWO BUTTON CONTROL PANEL

LIGHT - Switch A

Position 0: the light is off.
Position 1: the light is on.

SPEED - Switch B

This is used to start and set the speed of the motor, from 1 to 3, or with

continuous speed variator, depending on the version.

LIGHT - C

Motor operation indicator light.

2. FIVE BUTTON CONTROL PANEL

LIGHT- button

Pressed: the light is on
Released: the light is off

MOTOR button - 1, 2, 3, OFF

1: starts the motor at minimum speed
2: starts the motor at medium speed
3: starts the motor at maximum speed
OFF: stops the motor

3. ELECTRONIC CONTROL PANEL

Light pushbutton

• ON: light on (the pushbutton is lit);

• OFF: light off;

Pushbutton -

Press to reduce motor speed
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (exclud-

ing the light and the timer LEDs).

Pushbutton +

Press to increase motor speed
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (exclud-

ing the light and the timer LEDs).
(In the 4-speed version the pushbutton + blinks. The fourth speed remains

on for a set duration of time. After 15 minutes the motor returns to the

third speed).

Mode pushbutton

Function: it turns hood motor on and off.
The function “desired speed” enables to start the motor at the speed that

was selected before the hood was last turned off.
Optional:

WARNING:

version with remote control (some versions only).

Install the hood away from sources of electromagnetic waves, as these

could affect the correct operation of the electronic system.
Maximum operating distance: 5 metres. The maximum operating distance

could be less than 5 metres in case of electromagnetic interference by

other equipment.
Light pushbutton on remote control: light on/off.
– and + pushbutton: increase/decrease speed (to start the motor press

either the + or the – pushbutton).
Timer pushbutton: see instructions below.
Instructions for changing the code (only in case of malfunctions caused by

interferences):
Disconnect the hood from the power supply
Remove the cover of the remote control, change the code with the le-

vers.
Connect the hood to the power supply and make sure the lights and the

motors are off.
Press the timer pushbutton for 2 seconds. When the red LED of the control

panel lights up press any of the buttons on the control panel.

Timer and ‘filter clogged’ alarm pushbutton

• This function allows the automatic turning off of the hood after running

for 15 minutes at the speed previously set (the pushbutton shows a flicker-

ing light).

• After about 30 hours of running the pushbutton indicates the need for

washing the metal filters (the pushbutton shows a solid red light). To dis-

able the alarm press the pushbutton for a few seconds until the red light

turns off. Then turn the hood off and on again to check that the alarm has
disappeared.