Future Mobility Healthcare Inc. PRISM Supreme Installation And Operating Instructions Manual

PRISM Supreme Air Cushion

Installation and Operating Instructions

NOTE: Check all parts for shipping damages before using. In case of damage, do NOT use the

equipment. Contact the Equipment Supplier for further instructions.

WARNING

DO NOT install this equipment without first reading and understanding this instruction booklet. If you

are unable to understand these instructions, contact a healthcare professional, dealer or technical

personnel before attempting to install this equipment -

otherwise, injury or damage may occur.

NOTICE

Information contained within this document is subject to change without notice.

IMPORTANT

The Prism Supreme Air Cushion is a high-pressure relief cushion but NOT designed for use in the

treatment of pressure sores, or for those individuals at risk of developing pressure sores. Your

Therapist and/or Physician should be notified if you have any questions regarding pressure relief etc.

Introduction

The Supreme Air Cushion is designed for clients with challenging positioning and postural
support requirements. Using inflatable air inserts may allow adjusting seat cushion height in
four different areas.

Fig.1 (covers not shown)

ATTACHING THE PRISM SUPREME AIR CUSHION TO SEATING SURFACE

The Prism Supreme Cushion attaches to the wheelchair-seating surface through the use of
hook and loop fastening strips.

1. If the wheelchair has loop attachment strips, verify that the double-sided hook strips are securely
attached to the loop attachment strips on the bottom of the cushion.

2. Align the front edge of the cushion with the front edge of the seating surface. NOTE: The zipper is
located on the rear of the cushion.

3. Secure the cushion on the seating surface; making sure that the hook is securely attached to the
strips of loop on the cushion cover and the chair.

4. If the wheelchair has hook attachment strips, remove the double-sided hook strips from the cushion.

5. Continue with Steps 2 & 3.

6. To ensure proper pressure relief, verify that the user’s IT’s are situated in the visco pressure relief
foam area

To Adjust Air Inserts

Inflate air inserts by squeezing bulb valve until positioning is attained. To adjust area 1 connect bulb to
fitting 1, to adjust area 2 connect bulb to fitting 2, to adjust area 3 connect bulb to fitting 3, to adjust
area 4 connect bulb to fitting 4 (Fig.1).
Remove air from insert by pressing button on bulb valve.

MAINTENANCE - Cleaning Instructions

Foam

DO NOT immerse the Prism Supreme Air Cushion in water, instead, it should be wiped down with a
slightly dampened cloth. If the foam becomes contaminated due to incontinence, it SHOULD be
replaced.

Covers

USE mild detergent and machine-wash cold using gentle cycle. DO NOT USE fabric softeners or
bleach. Low tumble dry or air dry ONLY.

The cover is designed to protect the foam against a user's incontinence and to provide fire retardency,
so the Prism Supreme Cushion must not be used without its cover. If the cover is torn, it must be
replaced.

NOTE: Check that the cushion covers have the zipper at the rear bottom edge when
reinstalling.

(Inner & Outer)