
FU – Rely
User’s Manual
Thank you for your interest in Futura FU – Rely solar lighting system.
The FU – Rely has been designed to meet your need for a reliable and affordable portable light
and for charging mobile phones.
On/Off – 4
brightness levels
Charging
USB port
Adaptor charging
port
First use
Read the user's manual carefully before the first use.
The energy station must be fully charged before the first use. The indicator will become red
(flashing) when charging and green when fully charged. Keep the device switched off when
charging.
Place the lantern indoors and not close to flammable materials such as wood.
General specifications
There are 4 brightness levels. The duration of each one after one-day charging is as follows:

Attention: the light source is high brightness LED. Do not look at the light source directly.
The indicator will turn red when there is 1 hour of light remaining. The indicator will flash with red
light for 30 seconds in case the battery is low.
System specifications
Charging of the batteries
To avoid the battery damage, the light must be charged when the brightness starts to dim.
To charge the lantern with the solar light, put the solar module under sunlight and ensure that the
solar module is directly exposed to the sun. If the module is partly shaded, it will affect and
strongly reduce the power output. If you use the solar module in the Southern hemisphere, the
module must face the North; if you use the solar module in the Northern hemisphere, the module
must face the South.
The LED signal turns red when being charged; it turns green when fully charged. It is normal that
the charger gets hot when being charged. The item will be fully charged by solar panel after 10
hours (sunlight peak).
Maintenance
• Make sure that the product is not exposed to liquids.
• Clean dust or dirt on the solar module with wet cloth.
• Keep the product indoors when not in use.
• Charge the lantern at least once a month to prolong the battery lifespan
• The battery must be replaced after a certain number of years of use. This must be done by
an authorized technician.
Recycling
Do not throw any of the components after discarding. To minimize pollution, please recycle them.
All of the components used for manufacturing the system are recyclable. For more information visit
http://ec.europa.eu/environment/waste/weee/index_en.htm
www.futurasun.it
info@futurasun.it