FUTEK LTH300 Service Manual

+Excitation

RED

W I R I N G C O D E (WC1)

-Excitation
BLACK

+Signal
GREEN

-Signal
WHITE

+ OUTPUT

(COMPRESSION)

FUTEK
LABEL

0.28 [7.1]

0.01 [0.3]

SUPPORT

OUTER

Ø0.86 [Ø21.8]

ID. #

Ø0.46 [Ø11.7]

0.02 [0.4]

RING

5

4

3

2

1

LOADING SURFACE

DO NOT
APPLY LOAD
ON COVER

Ø0.89 [22.6]

NON LOADING SURFACE
DO NOT CONTACT

Ø0.98 [Ø24.9]

Ø0.13 [Ø3.2] nom.

Ø0.073 [Ø1.9] nom.

Ø0.19 [4.7]

STANDARD I.D.s

SEE CHART

0.7 [18.0]

0.1 [2.5]

0.35 [8.9]

NOTE:

WHILE TORQUING BOLTS, HIGH TENSION
FORCES WILL OCCUR DURING INSTALLATION,
WHICH COULD RESULT IN OVERLOADING THE
SENSOR. FUTEK RECOMMENDS CONNECTING
SENSOR TO A SYSTEM IN ORDER TO MONITOR
THE APPLIED FORCES. FUTEK IN NOT LIABLE
OR RESPONSIBLE FOR THE MISHANDLING OF
THE SENSOR DURING INSTALLATION.

}

This drawing is submitted solely for the information and

exclusive use of the original addressee. It is not to be divulged

in whole or in part, by any firm or individual without written

permission from FUTEK

CAGE CODE # 1X8M6