Fusionbrands MS-AB108 User Manual
MARINE ACTIVE SUBWOOFER
MS-AB108
v 1.0
SPECIFICATIONS
MAX POWER RATING 210 Watts
FREQUENCY RESPONSE 30Hz – 250Hz
LOW PASS FILTER (VARIABLE) 30Hz – 250Hz
TUNING Bass Reex
WOOFER SIZE 8” down ring
FUSE 10 Amp
DIMENSIONS Length 515mm - 20 1/4”
Width 233mm - 9 3/16”
Height 190mm - 7 1/2”
PRODUCT CONTENTS
1x MS-AB108 Active subwoofer
1x Power / GND/ Remote-ON wire loom
1x RCA Cable
Mounting Hardware
Manual
Warranty Card
CONTROL DESCRIPTIONS
LEVEL
This allows the adjustment of the amplifier input level. Turn clockwise to
increase the level. If the sound becomes distorted reduce the level.
LOW PASS FILTER (LPF)
This allows the adjustment of the highest frequency the Marine Active
Enclosure will produce.
This should be adjusted to blend with your main speakers. Typically, this
will be set to around 100Hz (approximately the central position of the
control knob).
INSTALLATION
Make sure the Marine Active Enclosure is firmly secured.
»
Check before drilling or cutting holes.
»
DO NOT work near gas tanks, fuel lines, hydraulic lines or electrical
»
wiring.
DO NOT mount the Marine Active Enclosure in such a way as to pinch
»
or damage the wires.
Make sure everything is firmly connected, before attaching the +12V
»
wire. Make sure the +12V wire is fused as close as possible to the
battery. ALWAYS use a fuse with the recommended rating.
(Wiring diagram on reverse)
RECORD YOUR PURCHASE DETAILS HERE:
MODEL NUMBER
DATE OF PURCHASE
AFFIX RECEIPT HERE
WARNING! Audio Systems can produce sound levels over 135dB. Continuous exposure to sound pressure levels over 100dB may cause permanent hearing loss!
www.fusionelectronics.com
PUBLISHED BY FUSION ELECTRONICS LIMITED: © Copyright 2009 by FUSION Electronics Limited. All rights reserved. Specifications and design are subject to change without notice.
YOU CAN HELP PROTECT THE ENVIRONMENT! Please remember to respect the local regulations: Hand in the non-working electrical equipment to an appropriate waste disposal center.
FUSE
POWER
REM
+12 GND
LOW INPUT
RIGHT
LEFT
LEVEL
MIN
MAX
30Hz
250Hz
L.P.F
MS-AB108
WIRING
Be sure to use the supplied power extension cable.
Connect the ground wire (Black wire) to the negative of the vessel
»
(Ground) Note: clean dirt, corrosion and paint to bare metal.
Connect the 12 volt (red wire) to the positive battery terminal of the
»
vessel; Make sure the fuse is close to the battery.
Connect the remote on (blue wire) to the remote turn on lead of the
»
Headunit. - If your head unit does not have a remote turn-on lead,
connect a switched 12v power lead to the unit.
Connect the RCA cables to source
»
Check all connections.
»
Finally, connect the power plug end of the power harness to the unit.
»
v 1.0
RCA cable
Connect to
subwoofer pre-out
on source.
Connect red wire to positive
(+12V) battery terminal
Connect blue wire to source
unit’s accessory lead or
switched 12 volt source
(Remote)
Power Plug
Connect black wire
to negative of vessel
(Ground)
Fuse
+12 Vessel Battery
www.fusionelectronics.com
PUBLISHED BY FUSION ELECTRONICS LIMITED: © Copyright 2009 by FUSION Electronics Limited. All rights reserved. Specifications and design are subject to change without notice.
YOU CAN HELP PROTECT THE ENVIRONMENT! Please remember to respect the local regulations: Hand in the non-working electrical equipment to an appropriate waste disposal center.
Loading...