Fusion Podium ESC 17T Operating Instructions Manual

PODIUM

Programmable RC Car Speed Controller

17 Turn

FS-POD17T

SpECIAL FEATUrES

• Fully programmable

• Excellent high output ESC

• Ultra high frequency & performance

• Forward & reverse w/ A.B.S (Anti-lock Brake System)

• Easy-to-use single button setup

• Speed up function

• Reverse delay function.

• High-temperature safety cut-off system prevents overheating damage

• Battery type for NiCd, NiMH & LiPo can be separately set.

• Safety protection from over discharge.

• No need to set the transmitter’s throttle switch.

• MOSFET transistor operation for maximum power output & the greatest efficiency.

• Factory installed radio, battery, and motor connectors.

opErATing insTrucTions

Please keep for future reference

Thank you for purchasing this PODIUM ESC 17T. We are sure you will be pleased

with its performance and features. In order to ensure that you obtain the

maximum benet from its operation, please read these instructions carefully.

SpEciFicAtions

Input power NiCd & NiMH 6-7 cells (7.2-8.4V)
Input power LiPo 2 cells
Operating frequency 1.0 kHz
B.E.C. Constant current 5.0V
B.E.C Output Voltage 1.0A
On-Resistance 0.006 ohms
Cutoff voltage NiCd/NiMH (4.0V) & LiPo (5.5V)
Motor Turns Limit 17 turns
Acceleration time delays 0.09, 0.16, 0.27 sec.
Weight with wires 33g
Case size 35 x 27 x 17 mm

COnnECTIOnS

SAFETy prECAUTIOnS

• Please read instructions carefully before using !

• Do not run the car in or around water. Never allow water, moisture, or other foreign materials
to enter the ESC.

• Only use 6 - 7 cells for NiCd/NiMH and 2 cells for LiPo.

• Always disconnect the battery pack from the speed controller when not in use.

• Always turn on the ESC after plugging it into the receiver and switching on the transmitter.

• Always check the battery polarity is correct – reverse polarity will damage the speed controller.

• Do not touch the transistors when they get hot !

• Be careful to avoid short-circuits between the various cables.

• Install the speed controller in such a way that it cannot come into contact with grease,
water, or oil.

mOUnT ThE SpEED COnTrOLLEr

• It is very important to determine the best location that allows efficient airflow
through the transistors for the ESC installation.

• Mount the ESC to the chassis using double-sided tape.