Fusion 16707, 16709, 16850 User Manual

Warranty Information

1-YEAR LIMITED PRODUCT WARRANTY

This product is covered under a one year limited warranty.

Fusion Products Ltd. warrants to the original purchaser that

this product is free from defects in materials and workmanship

for the period of one year warranty from date of purchase.

For Technical Support and/or Warranty inquiries

please contact:

Fusion Products Ltd.

Monday to Friday

8:30-5:00 PM EST

2905 Argentia Road, Unit 2,3

Mississauga, Ontario L5N 8G6

Tel: [phone] Fax: [phone]

Email: [e-mail]

4 SOLAR POST CAP

LIGHTS

FUSION PRODUCTS LTD.

User Manual for Models: 16707, 16709, 16850

Contents

Overview .............................................................................................................. 1

About Your Solar Light ................................................................................... 1

Getting Started ................................................................................................... 1

Important ............................................................................................................. 2

Operation ............................................................................................................. 2

Installation ........................................................................................................... 3

Battery Replacement ...................................................................................... 4

Trouble Shooting Tips .................................................................................... 5

Care Information .............................................................................................. 5

Warranty Information .................................................................................... 6

Trouble Shooting Tips

If your solar light does not come on at dusk despite following all
instructions please try the following steps:

1. Make sure that the solar light is not affected by any other light
source.

2. Ensure the solar light does not stand in the shade all day.

3. Check to see if the batteries are installed correctly.

4. If there is a protective film on the solar panel carefully remove
this.

5. Remove the pull tab from the battery compartment.

Care Information

1. Clean any dirt and debris from the solar panel. The panel cannot
recharge if the light is obstructed. Use a soft cloth to clean the
panel. Do not use abrasives or chemicals that might scratch or
damage the UV coating.

2. In a region where snow and ice are likely and the light assembly
is covered with snow for an extended period of time the batteries
will require a recharge for at least 8 hours.

5

Battery Replacement

STEP 1:

Turn the solar housing in a counter-clockwise direction until it
separates from the lens (Figure 5).

STEP 2:

Remove the battery compartment cover. Carefully remove the old
battery from the battery compartment (Figure 6).

STEP 3:

Replace the battery with an equivalent new solar rechargeable
battery; ensuring the correct polarity is observed (Figure 6).

STEP 4:

Re-attach the solar housing to lens by turning clockwise until
secure (Figure 7).

Caution: Rechargeable batteries contain Nickel-Cadmium or
Nickel-Metal Hydride and must be recycled or disposed of
properly. Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable batteries. Do
not dispose of batteries in fire. Batteries may explode or leak.

Overview

This product is designed to the highest technical specifications and
standards. It will supply years of maintenance free use. Please read
these instructions thoroughly prior to installation, then store in a
safe place for future reference. If at any time you are unclear about
this product, or require further assistance please do not hesitate to
contact our trained professionals operating the customer support
line at 1-877-615-1378 Monday to Friday between the hours 8:30
AM to 5:00 PM Eastern Standard Time or email
[e-mail]

About Your Solar Light

During the day your solar panel will convert the sun's light and/or
UV rays into electrical power that will charge the rechargeable
battery. When it becomes dark, the solar light will turn on using
the power stored on the rechargeable battery as it will detect no
day light. The units light output strength and time depends on how
many hours and how much sunlight and/or UV rays your panel
absorbs throughout the day.

For maximum output place the solar panel in an area where there
is direct sunlight for at least 8 hours in a given day. Do not install
your solar light in a shaded area. The selected location should not
be near night time light sources such as; porch lights, street lights
or pool lights as these may cause the solar light to turn off
prematurely.

Getting Started

Please do not throw away any packing material until all parts are
verified as present.

4

1

Important

• Fully charge the battery before first use. Charge under direct

sunlight for 2 days.

• For best results, locate your solar lamp in a position where it

can get direct sunlight on the solar panel and generally free
from cover and shade.

• Keep your solar lights away from other night-time light

sources, such as streetlights.

• Make sure the solar panels are not covered by dust, snow

and debris. Clean it with a soft damp cloth or paper towel
periodically. Avoid the use of abrasive cleaning agents.

• Use only rechargeable batteries for your solar lights. Replace

with a new battery of the same size each year for optimum
performance.

• The performance of the solar light will vary with the time of

year. It will deliver more light when it has had a full day in
the sun rather than a day in overcast weather.

Operation

For First Time Use:

STEP 1:

Remove the lens from the solar housing
by carefully holding onto the solar
housing and turning the lens in a
counter-clockwise direction.

STEP 2:

Remove the pull tab from the battery
compartment.

STEP 3:

Secure lens back to solar housing.

STEP 4:

Fully charge the battery before first
use. charge under direct sunlight for 2
days. Your solar light will automatically
turn on once it gets dark.

Installation

STEP 1:

Select the correct adapter size size
depending on the size of the post.

STEP 2:

Mark holes and pre-drill if necessary before
securing adapter to post with screws (Figure

2). If attaching adapter to composite, vinyl,
PVC, or other; secure to post by pushing
adapter onto post (Figure 3).

STEP 3:

Attach the assembled light to the adapter by
turning clockwise until secure (Figure 2,3).

Routed Post Sleeve Option

STEP 1:

Remove the lens from the solar housing by
carefully holding onto the solar housing and
turning the lens in a counter-clockwise
direction.

STEP 2:

Select the correct adapter size size depending
on the size of the post.

STEP 3:

Secure adapter to post by pushing adapter
onto post (Figure 4).

STEP 4:

Attach solar housing to adapter by turning
clockwise until secure (Figure 4).

2

3