Furrion FEFS48F7A User Manual

USER’S MANUAL

LED FHD TV SET

48” FHD LED TV FEFS48F7A

z Introduction

z Warning

z Caution

z Main Unit Description

z Remote Control

Contents

z OSD Basic Adjustment

z Specifications

Troubleshooting

z

1

Introduction

Thank you very much for purchasing your LED TV. It serves as a normal colour TV

To

and a PC monitor.

carefully and keep it handy for future reference.

Locate the receiver in the room where direct light does not strike the screen. Total

ķ

darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect

lighting is recommended for comfortable viewing.

Allow enough space between the receiver and the wall to permit ventilation.

ĸ

Avoid excessively warm locations to prevent possible damage to the cabinet or

Ĺ

enjoy your set fully from the very beginning, read this manual

INSTALLATION

premature component failure.

This TV can be connected to AC 100-240V~ 50/60HZ.

ĺ

Do not install the TV in a location near heat sources such as radiators, air ducts,

Ļ

direct sunlight, or in closed compartments and closed areas. Do not cover the

ventilation openings when using the

The

ļ

off. Wait

Ľ

are trademarks of Dolby Laboratories.

indicator light will last for about 30 seconds after the power has been turned

until the indicator light goes out before repowering the

Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol

TV.

2

Warning

RISK OF ELECTRIC SHOCK

CAUTION: TO AVOID THE RISK OF ELECTRIC SHOCK.

DO NOT REMOVE COVER (OR BACK).

NO USER- SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

This symbol is intended to alert the user to avoid the risk

of electric shock. This equipment may only be disassembled

by qualified service personnel.

CAUTION

DO NOT OPEN

.

This symbol is intended to alert the user to the presence

of important operation and maintenance instructions in

the literature accompanying the equipment.

Class I structures of equipment should be connected to the grid

power output with a protective earth connection on the socket. Power plug as a broken applianceˈ

be easy to

operate.

broken installations should

This equipment is a Class Ⅱ or double insulated electrical appliance. It has been designed in such a way that it does not require a safety connection to electrical earth.

3

&DXWLRQ

+LJK YROWDJHV DUH XVHG LQ WKH RSHUDWLRQ RI WKLV SURGXFW

'R QRW RSHQ WKH SURGXFWV FDVLQJ 5HIHU VHUYLFLQJ

WR TXDOLILHG VHUYLFH SHUVRQQHO 

&DXWLRQ

7R

SUHYHQW ILUH RU HOHFWULFDO VKRFN KD]DUG GR QRW H[SRVH

WKH PDLQ XQLW WR

OLTXLGV

ZLWK

OLTXLGV

ZLWK

OLTXLGV VXFK

ZLWK OLTXLGV

ZLWK

UDLQ RU PRLVWXUHˈ

YDVHV

DV

VXFK

VXFK DV

YDVHV

DV

YDVHV RQ

DV YDVHV

QRW

GR

QRW

GR

QRW SODFH

GR QRW

GR

DSSDUDWXV

WKH

RQ

RQ WKH

DSSDUDWXV

WKH

DSSDUDWXV

WKH DSSDUDWXV

SODFH

SODFH REMHFWV

REMHFWV

REMHFWV ILOOHG

ILOOHG

&DXWLRQ

'R QRW GURS RU SXVK REMHFWV LQWR WKH WHOHYLVLRQ FDELQHW

VORWV RU RSHQLQJV 1HYHU VSLOO DQ\ NLQG RI OLTXLG RQ WKH

WHOHYLVLRQ UHFHLYHU

&DXWLRQ

$YRLG H[SRVLQJ WKH PDLQ XQLW WR GLUHFW VXQOLJKW DQG RWKHU

VRXUFHV RI KHDW 'R QRW VWDQG WKH WHOHYLVLRQ UHFHLYHU GLUHFWO\ RQ

RWKHU SURGXFWV ZKLFK JLYH RII KHDW H J YLGHR FDVVHWWH SOD\HUV

DQG DXGLR DPSOLILHUV 'R QRW EORFN WKH YHQWLODWLRQ KROHV LQ WKH

EDFN FRYHU 9HQWLODWLRQ LV HVVHQWLDO WR SUHYHQW IDLOXUH RI HOHFWULFDO

FRPSRQHQWV 'R QRW VTXDVK WKH SRZHU VXSSO\ FRUG XQGHU WKH

PDLQ XQLW RU RWKHU KHDY\ REMHFWV



Never stand on, lean on or suddenly push the product

or its stand. You should pay special attention to

children.

Do not place the main unit on an unstable cart stand,

shelf or table. Serious injury to an individual and

damage to the television may result if it should fall.

Caution

of time, it is advisable to disconnect the AC power

from the AC outlet.

When the product is not used for an extended period

Caution

is therefore breakable. This product must not be dropped

or banged. If the LED Panel breaks be careful of being

injured by broken glass.

The LED panel used in this product is made of glass and

5

Main unit description

Control Panel Button Function

VOL+ : Volume up. VOL- : Volume down. CH+ : TV channel up. CH- : TV channel down. MENU : Press to select the main menu. SOURCE : Select the input signal. POWER : Switch on when at standby mode or enter the standby mode.

TV Terminal Connections

1 23 54678910111213

1. EARPHONE OUT terminal

2. COAXIAL OUT terminal

3. AUDIO IN (L & R) terminal

4. VIDEO IN terminal

5. COMPONENT IN (Y Pb Pr) terminal

6. HDMI 1 IN terminal

7. HDMI 2 IN terminal

8. HDMI 3 IN (ARC) terminal

9. VGA IN terminal of simulation signal of PC

10. PC AUDIO IN terminal

11. RF IN terminal (antenna)

12. USB INPUT terminal (for SERVICE only)

13. AUDIO OUT (L & R) terminal

6

MTS /AUD IO

ASP ECT PM ODE S MODE

1 2

5

4

7 8 9

0

DIS PLAY EPG AUT O

SLE EP

MEN U

CH

FAV

ENT ER

INF O

F.LIS T C.LI S T

SOU RCE

CC

3

6

VOL

EXI T

Remote control

POWER: Power on/off button, press once to turn the TV on and press

again to turn the TV off.

MUTE: Press this button to mute or restore sound.

MTS/AUDIO: When stereo program is received, press this key to

switch sound system between mono and stereo.

When SAP program is received, press this button to switch sound

system between mono and SAP

When stereo and SAP program is received, press this key to switch

among mono, stereo and SAP.

Press this key to show the list of audio languages available for the

current channel in ATSC.

ASPECT: Press to

PMODE: Select picture mode.

SMODE: Select sound mode.

0-9: Select and switch to a channel using 0 - 9.

Switch the program digit.

-/--:

: Switch back and front between the current and previous channels.

DISPLAY: Display TV information.

EPG

Enter electronic program guide

AUTO: Adjust the picture automatically in pc mode.

RED, GREEN, YELLOW, CYAN:

SLEEP: Set the sleep timer.

SOURCE: Press to change signal source.

ENTER: Enter the selected option or perform the selected operation.

MENU: Press this button to enter the main menu.

EXIT: Exit the OSD (On-screen display).

CH+/CH-: Change the channel.

CC: Press this key to select the CC ,ON or OFF mode and CC on Mute .

INFO: Display some information of current program in TV mode.

VOL+/VOL-: Adjust the volume.

FAV: Switch between custom set "Favorite List".

F.LIST: Press this key to display the Favorite List mode.

C.LIST: Press this key to display the Channel List mode.

adjust picture ratio.

This button is not available.

7