Funkwerk GSM 900, GSM 1800, UMTS, ACTIVE ANTENNA User Manual
Ein Unternehmen der Funkwerk AG.
155 8000 0.03
Active antenna
18
Introduction
Thank you very much for opting in favour of the ACTIVE ANTENNA of Funkwerk
Dabendorf GmbH!
The ACTIVE ANTENNA takes care of the very best transmission and reception
power and thus ensures improved operation of your UMTS terminal device.
First of all, and based on the data concerning the scope of supplies please check
whether all parts are available.
Declaration of Conformity
We, Funkwerk Dabendorf GmbH, declare that we bear the entire responsibility for
the product ACTIVE ANTENNA fully complying with the provisions of the European
Council Directive 1999/5/EC.
0681
The Declaration of Conformity is open to inspection under
www.fwd-online.de/con-
formity
.
Safety Instructions
The antenna is only to be used for the purpose indicated by the manufacturer.
Caution when unpacking:
Danger of suffocation for infants when small pieces are swallowed!!
Do not dispose of in a fire!
Persons must observe a distance of at least 20cm to the antenna! Special
caution is required for persons wearing a pacemaker!
Deutsch English Türk
19
The device may only be opened and serviced by specialist personnel!
Only use approved accessories!
Before using the antenna in/on buildings, please make sure you are informed
of the minimum distances required to sensitive devices (e.g. in hospitals, at gas
stations, at places labelled as especially endangered, including explosive materials, combustible fluids and gases etc.)
Do not rely on this device for emergency communication!
Use exclusively the components included in the scope of delivery. The fixedconnected coaxial cable must not be subjected to tension in the laid status.
Route the cable so that it cannot rub against other objects or be crushed. The
bending radius of 20 mm must not be fallen below!
The coaxial line may not be extended or shortened! Product Approval expires!
If the device is not used for a longer period of time (e.g. vacation), the wall
power supply should be pulled out of the power socket!
A specialist with know-how about the applicable professional standards
should be commissioned with mounting the antenna outdoors!
With the installation on a house or on an antenna mast, suitable measures
are to be taken for lightning protection on the house!
Instructions for Disposal
Do not dispose of the device in domestic waste!
Electronic devices are to be disposed of in compliance with the directive
governing old electric and electronic devices via the local collection sites
for electronic waste!
WEEE-Reg.-No. DE 81447333
Deutsch English Türk
20
Function Description
The Active Antenna À is suitable for the frequency band range GSM 900, GSM 1800
and UMTS Band I. It supports the transmission process GPRS, HSCSD, EDGE,
UMTS, HSDPA and HSUPA. The connection to the terminal devices is effected using
the mounting UMTS data stick included in the supplies.
The set of an active antenna consists of a basic device [antenna with integrated amplifier], a 15 m long coaxial line, a wall power supply unit and a mounting with
integrated connecting antenna for UMTS data sticks.
The following connections are found on the mounting:
• Plug connector for the connection of the coaxial line to the active
antenna
• 2,1mmbarrelconnectorforsupplyvoltage
The supply voltage required is provided by the enclosed external power supply unit
(8 V, 0,9A).
The active antenna amplifies the UMTS mobile radio signal between the terminal
device and the outdoor antenna in transmission and receiving direction. Furthermore, an additional yield of approx. 7dB is achieved through the directive array. In
the GSM frequency bands the antenna is passive, no boosting is effected.
Note transmission direction!
Deutsch English Türk
Loading...